# Industrial robot: Footprint

Source page: https://www.materialinsights.org/products/p_industrial_robot/prod-footprint/

#### Raw materials in one unit

Every commodity and chemical inside one unit, traced through its components by the site, with its emission factor and emissions

| Material | Amount (kg) | Through | Emission factor (kg CO2e per kg) | Emissions (kg CO2e) |
|---|---|---|---|---|
| Copper | 5244 | Electric motor, Insulated power cable | 3.965 | 20,792.5 |
| Steel | 3636 | Electric motor | 1.92 | 6981.1 |
| PVC | 1080 | Insulated power cable | – | – |
| Aluminium | 114 | Electric motor | 14.8 | 1687.2 |

Worked out from data

#### The site's estimate

Emissions of one unit worked out by the site from its materials and energy, for the world and India, with the share of mass covered by emission factors

| Stage | Place | Emissions (kg CO2e) | Mass covered by factors |
|---|---|---|---|
| Making | World | 29,461 | 89% |
| Use | World | – | – |
| Making | India | 29,461 | 89% |
| Use | India | – | – |

Worked out from data

#### Energy in use

Energy one unit uses per year of use, by carrier
 Energy in use

- [El Electricity](https://www.materialinsights.org/energy/electricity/) 6913 kWh over 36,000 hours of continuous operation (study total, not per year) The study's own figures for one small collaborative arm (a UR5) doing a 6 s pick-and-place cycle with a 2 kg workpiece: 6,913 kWh after 36,000 h of continuous operation, with a constant draw of 100 W ^[4]. The study gives no figure per year or lifetime in years. The duty is the study's, not an average for all robots.

as of 2026-11-13. Given as the study's total over its 36,000-hour horizon; no source gives a robot's electricity use per year.

#### Emissions by stage

Published life-cycle emissions of one unit in four stages (making, logistics, use, end of life), with their split, place and variant

| Stage | Value | Range | Unit | Place | Year | Source |
|---|---|---|---|---|---|---|
| Making | 462.2 | – | kg CO2e per robot | Germany | 2021 | ^[4]; one small collaborative arm (a UR5) with its controller, table value (Table 2) |
| Making | – | up to 1400 kg CO2e per robot | kg CO2e per robot | World | 2026 | ^[19]; cross-check: industrial robots had cradle-to-gate impacts of less than 1.40 t CO2e per unit in a meta-analysis |

as of 2026-11-13. The UR5 study gives 462.2 kg CO2e for making the arm and controller and a total of 4,237 kg for that plus 36,000 hours of operation on German electricity without repairs, and says operation is 88% or more of the total [4]. It gives no separate use, logistics or end-of-life figure, so only making is shown and no shares are given.

#### End of life

What happens to a unit when it is thrown away: collection, reuse, recycling and disposal shares, by place

| Route | Share | Place | Source |
|---|---|---|---|
| Easily recyclable material (share of the robot, as stated by ABB) | 95 | World | ^[9] |

as of 2026-11-13

#### Recovered as

The commodities and chemicals recovered at end of life, with recovery rates
 Recovered as 4

- [St Steel](https://www.materialinsights.org/commodities/steel/) Recycling Cast iron and steel parts; no recovery rate given.
- [Al Aluminium](https://www.materialinsights.org/commodities/aluminum/) Recycling Housings and covers; no recovery rate given.
- [Cu Copper](https://www.materialinsights.org/commodities/copper/) Recycling Cables and windings; no recovery rate given.
- [REE Rare earths](https://www.materialinsights.org/commodities/rare_earths/) Recycling Motor magnets; no source gives magnet recovery from robots.

as of 2026-11-13

#### End of life in India

Collection and recycling in India, including the informal sector

No opened source gives collection or recycling rates for industrial robots in India or elsewhere, or describes informal recycling or extended producer responsibility for them. ABB says around 95% of a robot is easily recycled material and that it has reconditioned over 12,000 robots in 30 years ^[9]. ABB's manual asks that robots be dismantled, recycled or reused responsibly under local law ^[5].

as of 2026-11-13

#### Sources

1. [Impact of Cycle Time and Payload of an Industrial Robot on Resource Efficiency (Stuhlenmiller, Weyand, Jungblut, Schebek, Clever and Rinderknecht, Robotics 10(1), 33)](https://www.mdpi.com/2218-6581/10/1/33) MDPI, 2021
2. [ABB IRB 6710 product manual (3HAC085695-001, revision A), section 8 Decommissioning, environmental information (copy hosted by ManualsLib; ABB's own copy could not be opened)](https://www.manualslib.com/manual/3242393/Abb-Irb-6710.html?page=616) ABB, hosted by ManualsLib, 2023
3. [Sustainability approach: sustainability along the robot life cycle](https://www.industrial-production.de/industrial-robots/sustainability-approach-sustainability-along-the-robot-life-cycle.htm) industrial-production.de
4. [The life cycle climate impacts of industry-specific machinery technologies: A meta-analysis (Arias-Castillo and Viere, Resources, Conservation and Recycling Advances 31, 200354)](https://publikationen.bibliothek.kit.edu/1000194678/184262227) Karlsruhe Institute of Technology repository, 2026

## Other sections

- [Summary](https://www.materialinsights.org/products/p_industrial_robot/index.md)
- [Working](https://www.materialinsights.org/products/p_industrial_robot/prod-working/index.md)
- [Bill of materials](https://www.materialinsights.org/products/p_industrial_robot/prod-bom/index.md)
- [Use case](https://www.materialinsights.org/products/p_industrial_robot/prod-use/index.md)
- [Supply chain](https://www.materialinsights.org/products/p_industrial_robot/prod-supply/index.md)
- [Evolution](https://www.materialinsights.org/products/p_industrial_robot/prod-evolution/index.md)
- [Interventions](https://www.materialinsights.org/products/p_industrial_robot/prod-interventions/index.md)
