# Steam turbine: Working

Source page: https://www.materialinsights.org/products/p_steam_turbine/prod-working/

#### What it is

The product and the job it does, in a short paragraph

A steam turbine turns the energy of high-pressure steam into the spin of a shaft that drives an electric generator, a pump or a compressor. This node covers turbines for power stations and industry (HS 8406.81 above 40 MW and 8406.82 up to 40 MW), not ship propulsion. The functional unit is one 500 MW turbine set, without its generator, boiler or, in most studies, its condenser. Small industrial and combined-cycle turbines are variants ^[4]^[9].

as of 2026-11-15

#### How it works

How it does its job, step by step in plain words

Steam from a boiler, a reactor loop, a geothermal well or the exhaust-heat boiler of a gas turbine enters the high-pressure section at high pressure and temperature. It expands through rows of fixed blades, which act as nozzles, and moving blades on the rotor, which turn the pushing steam into rotation. Large utility sets pass the steam back to the boiler for reheating and then through intermediate and low-pressure sections, with several steam bleeds that warm the boiler feed water. The exhaust flows into a condenser under vacuum, which lets the steam expand further. The shaft turns at 3,000 rpm on 50 Hz grids or 3,600 rpm on 60 Hz grids, and at half that speed in many large nuclear sets ^[9]^[13]^[4].

as of 2026-11-15

#### Key specifications

The numbers that describe it, each with unit, variant, year and source

| Spec | Value | Unit | Variant | Year | Source |
|---|---|---|---|---|---|
| Largest rated output of the maker's thermal-plant range | 1200 | MW | Utility | – | ^[9] |
| Main steam pressure, maximum | 28 | MPa | Utility | – | ^[9] |
| Main steam temperature, maximum (reheat up to 630 degrees C) | 600 | degrees C | Utility | – | ^[9] |
| Steam turbine of a US supercritical coal design study: output and steam conditions 24.1 MPa, 593 degrees C, reheat 593 degrees C | 610 | MW | Utility | 2015 | ^[5] |
| 800 MW unit in an NTPC tender: throttle steam 270 kg/cm2 (abs) and 600 degrees C, reheat 600 degrees C, 3,000 rpm | 800 | MW | Utility | 2015 | ^[17] |
| Large reactor turbine output range (Arabelle 1000 and 1700), half-speed shaft | 700 to 1,900 | MW | Nuclear | – | ^[13] |
| Low-pressure rotor of a 700 MW nuclear turbine, heaviest lift | 85 | tons | Nuclear | – | ^[11] |
| Mass of one Arabelle half-speed nuclear turbine, one of four for a 4.8 GW plant (about 1,200 MW each, calculated) | nearly 4,000 | tons | Nuclear | 2018 | ^[34] |
| Combined-cycle steam turbine output range (STF-D650) at 190 bar and 585 degrees C | 200 to 700 | MW | Combined-cycle | – | ^[12] |
| Isentropic efficiency of backpressure turbines in three typical CHP systems of 500 kW, 3 MW and 15 MW | 52.5 to 78.0 | % | Industrial | 2015 | ^[4] |

as of 2026-11-15. Ratings are the makers' own maximum or catalogue values, not measured fleet averages. The NETL row is a design study of a 550 MW (net) plant. The Arabelle mass is the maker's round figure; the page does not say whether the generator is included or which ton is meant.

#### Variants

The variants whose make-up or footprint differs a lot, what defines each and its share of units

| Variant | Defining spec | Share | Year | Source |
|---|---|---|---|---|
| Utility | Large condensing turbines of up to 1,200 MW behind coal, oil, gas, biomass or solar-thermal boilers, with steam near 24 to 28 MPa and 593 to 600 degrees C and reheat; 52 'utility fossil' units ordered in 2025 | 8.8 | 2025 | ^[5]^[9]^[1]; share of units ordered in 2025, calculated as 52 of 588 |
| Nuclear | Turbines for light-water reactors of 700 to 1,900 MW, often at half speed; 17 units and 11,310 MW ordered in 2025 | 2.9 | 2025 | ^[13]^[1]; 2.9% of units ordered in 2025 |
| Combined-cycle | Steam turbine of 100 to 700 MW fed by the exhaust-heat boiler of one or more gas turbines; 114 units and 27,485 MW ordered in 2025 | 19.4 | 2025 | ^[12]^[1]; 19.4% of units ordered in 2025 |
| Industrial | Backpressure or extraction turbines from under 100 kW to over 250 MW in paper, chemical, sugar and similar plants, often combined heat and power; 194 units ordered in 2025 | 33 | 2025 | ^[4]^[1]; share of units ordered in 2025, calculated as 194 of 588 |
| Geothermal | Turbines on geothermal steam; the Theistareykir station has two 45 MW turbine-generator units; thermal renewables (biomass, geothermal, solar) were 196 units, 33.3% of 2025 orders, but 3.5% of ordered capacity | – | 2025 | ^[6]^[1]; no separate geothermal share found |

as of 2026-11-15

#### Limits

The physical limits set by science and the engineering limits of today's design, with today's value

| Limit | Kind | Limit | Today | Unit | Source |
|---|---|---|---|---|---|
| Carnot limit: the share of heat that can become work is set by the gap between steam temperature and the cold sink. No limit value is given in the sources, so only the best measured plant is shown | Physical | – | 49.37 | % net efficiency, best coal unit (not a limit) | ^[15] |
| Steam temperature of mature plant materials; the nickel-alloy programme aimed at steam up to 760 degrees C | Engineering | 760 | 600 | degrees C | ^[15]^[16] |
| Maximum temperature of the Ni-1.25Cr-Mo-V rotor steel now used for high temperatures, set by stress in the first-stage disk | Engineering | 480 | 480 | degrees C (around) | ^[23] |
| Largest rated single-turbine output of a maker's coal and gas plant range (nuclear sets reach about 1,900 MW) | Engineering | – | 1200 | MW | ^[9]^[10]^[13] |

as of 2026-11-15

#### Science it relies on

The science principles it works by or is limited by
 Limited by

- [Carnot's limit on heat engines](https://www.materialinsights.org/science/carnot_cycle/) Efficiency is capped by the temperatures of the steam and the condenser, so makers push steam hotter.
- [Second law of thermodynamics](https://www.materialinsights.org/science/second_law_thermodynamics/) Some heat must be rejected to a cold sink, which is why a condenser is needed.
 Relies on

- [Latent heat](https://www.materialinsights.org/science/latent_heat/) Boiling takes in and condensing gives out a large amount of heat at one temperature.
- [Bernoulli's principle](https://www.materialinsights.org/science/bernoulli_principle/) Fixed blades trade steam pressure for speed before the moving blades.

as of 2026-11-15

#### Sources

1. [Is Steam the Answer to the Gas Turbine Bottleneck? (2025 orders, Dora Partners and McCoy Power Reports data)](https://www.turbomachinerymag.com/view/steam-turbines-gas-turbine-bottleneck-siemens-energy) Turbomachinery International, 2026
2. [Catalog of CHP Technologies, Section 4: Technology Characterization, Steam Turbines](https://19january2017snapshot.epa.gov/sites/production/files/2015-07/documents/catalog_of_chp_technologies_section_4._technology_characterization_-_steam_turbines.pdf) US Environmental Protection Agency, CHP Partnership, 2015
3. [Cost and Performance Baseline for Fossil Energy Plants, Volume 1a: Bituminous Coal (PC) and Natural Gas to Electricity, Revision 3](https://www.netl.doe.gov/projects/files/CostandPerformanceBaselineforFossilEnergyPlantsVolume1aBitCoalPCandNaturalGastoElectRev3_070615.pdf) US DOE National Energy Technology Laboratory, 2015
4. [Life cycle assessment of the Theistareykir geothermal power plant in Iceland](https://www.sciencedirect.com/science/article/pii/S0375650522001766) Elsevier (Geothermics), 2022
5. [Steam Turbines for Thermal Power Plants (Up to 1,200 MW)](https://power.mhi.com/products/steamturbines/lineup/thermal-power/1200) Mitsubishi Heavy Industries, Mitsubishi Power
6. [Steam Turbine Generators (brochure)](https://www.toshiba.com/taes/cms_files/stg_brochure.pdf) Toshiba Energy Systems
7. [STF-N700 steam turbine (product page)](https://www.ge.com/steam-power/products/steam-turbines/stf-n700) GE Vernova
8. [STF-D650 and STF-A650 steam turbines (product page)](https://gevernova.com/steam-power/products/steam-turbines/stf-d650-stf-a650) GE Vernova
9. [Arabelle turbine for large reactors](https://www.arabellesolutions.com/our-technology/pioneering-steam-turbines/arabelle-turbine-for-large-reactors) Arabelle Solutions
10. [China's Pingshan Phase II Sets New Bar as World's Most Efficient Coal Power Plant](https://www.powermag.com/chinas-pingshan-phase-ii-sets-new-bar-as-worlds-most-efficient-coal-power-plant) POWER Magazine, 2023
11. [Materials Matter: The Advanced Ultrasupercritical Boiler Consortium](https://www.power-eng.com/operations-maintenance/materials-matter-the-advanced-ultrasupercritical-boiler-consortium/) Power Engineering, 2016
12. [Salient technical features, IFB No. 40034538: two 800 MW steam turbine generator units with auxiliaries](https://ntpctender.ntpc.co.in/uploads/tech_job_17622.html) NTPC Limited, 2015
13. [Development of New Heat Treatment Method to impart high creep strength and high toughness to rotor material for condensing steam turbine (Jain, Tsurusaki, Ikeno, Terada, Morioka)](https://core.ac.uk/download/188226496.pdf) Turbomachinery Laboratory, Texas A&M Engineering Experiment Station, 2018
14. [Full Steam Ahead: Egypt Picks World's Largest Steam Turbines From GE For New Nuclear Power Plant](https://www.ge.com/news/reports/full-steam-ahead-egypt-picks-worlds-largest-steam-turbines-ge-new-nuclear-power-plant/) GE Reports, 2018

## Other sections

- [Summary](https://www.materialinsights.org/products/p_steam_turbine/index.md)
- [Bill of materials](https://www.materialinsights.org/products/p_steam_turbine/prod-bom/index.md)
- [Use case](https://www.materialinsights.org/products/p_steam_turbine/prod-use/index.md)
- [Supply chain](https://www.materialinsights.org/products/p_steam_turbine/prod-supply/index.md)
- [Footprint](https://www.materialinsights.org/products/p_steam_turbine/prod-footprint/index.md)
- [Evolution](https://www.materialinsights.org/products/p_steam_turbine/prod-evolution/index.md)
- [Interventions](https://www.materialinsights.org/products/p_steam_turbine/prod-interventions/index.md)
