# Carnot's limit on heat engines: Technologies

Source page: https://www.materialinsights.org/science/carnot_cycle/sci-technologies/

#### Technologies

The technologies that rely on it, and how each one uses it
 Limits 33

- [Stm Steam engine](https://www.materialinsights.org/technologies/steam_engine/) Carnot's essay was written about steam engines, and his limit caps what any of them can get from the gap between boiler and condenser temperatures.
- [CCGT Gas turbines and combined cycle](https://www.materialinsights.org/technologies/e_gas_turbines/) Efficiency rises with the gap between the turbine inlet temperature and the surroundings, so designers push inlet temperatures ever higher.
- [Jet Aviation propulsion](https://www.materialinsights.org/technologies/e_aviation/) A jet engine is a gas turbine, so the share of fuel heat it can turn into thrust work is bounded by the temperatures it works between.
- [ICE Internal combustion engines and gensets](https://www.materialinsights.org/technologies/e_engines/) No piston engine can turn all its heat into work; the largest share it could is set by the temperatures it works between.
- [Tr Farm tractor](https://www.materialinsights.org/technologies/farm_tractor/) Like every heat engine, a tractor engine can turn only part of its fuel's heat into work.
- [HP Heat pumps, air conditioning and refrigeration](https://www.materialinsights.org/technologies/e_heat_pumps/) Run in reverse, the Carnot limit caps how much heat a unit of work can move, and that amount falls as the temperature gap grows.
- [Bag Bagasse and black-liquor cogeneration](https://www.materialinsights.org/technologies/e_bio_cogen/) The electricity a mill can make depends on the temperature drop of its steam, which is why higher pressure and temperature raise exportable power.
- [BmC Biomass combustion and CHP](https://www.materialinsights.org/technologies/e_bio_combustion/) The steam cycle can turn only part of the heat into work, set by its temperatures; biomass boilers run cooler steam than the best coal plants, so efficiency is lower.
- [CB Carnot batteries](https://www.materialinsights.org/technologies/e_carnot/) Carnot showed in 1824 that the work an ideal heat engine gets from heat is fixed only by the temperatures between which it works, which caps the discharge of every Carnot battery.
- [CHP Combined heat and power](https://www.materialinsights.org/technologies/e_chp/) An ideal engine's efficiency depends only on the temperature difference, so some heat must always be rejected; CHP puts that rejected heat to use.

Show 23 more

- [CSP Concentrated solar power](https://www.materialinsights.org/technologies/e_csp/) The hotter the receiver fluid, the more of its heat the turbine can turn into work, which is why towers at 565 °C beat troughs at 390 °C.
- [NFR Nuclear fission reactors](https://www.materialinsights.org/technologies/e_fission/) Water-cooled reactors give fairly cool steam, which keeps their thermal efficiency near a third.
- [Shp Ship propulsion](https://www.materialinsights.org/technologies/e_marine/) Marine diesels and steam turbines are heat engines, so only part of the fuel's heat can become shaft work.
- [OTEC OTEC and salinity power](https://www.materialinsights.org/technologies/e_otec/) With only about 20 °C between warm and cold water, the Carnot efficiency is at most about 7%, since a heat engine's efficiency depends on the temperature difference.
- [Rail Rail traction](https://www.materialinsights.org/technologies/e_rail_traction/) Steam and diesel locomotives are heat engines, so only part of the fuel's heat can become work.
- [ICV Combustion road vehicles](https://www.materialinsights.org/technologies/e_road_ice/) Like every heat engine, a car engine can turn only part of its heat into work, the share set by the temperatures it works between.
- [ST Steam turbines and thermal power plants](https://www.materialinsights.org/technologies/e_steam_turbines/) Carnot showed that the share of heat a steam plant can turn into work is set by the temperatures it works between, so plants push steam ever hotter.
- [WtE Waste-to-energy](https://www.materialinsights.org/technologies/e_waste_to_energy/) Turning steam heat into electricity is a heat engine step, whose efficiency Carnot tied to the temperature difference in 1824; Rankine worked out the steam cycle used in such plants in his 1859 manual.
- [WHR Waste-heat power (steam Rankine)](https://www.materialinsights.org/technologies/e_whr_rankine/) A heat engine's efficiency is set by its temperature difference; waste-heat Rankine cycles, steam or organic, typically reach 30% to 50% of the Carnot efficiency.
- [Aeroplane](https://www.materialinsights.org/products/p_aeroplane/) A jet engine is a heat engine, so the temperature it can run at limits its efficiency.
- [Agricultural tractor](https://www.materialinsights.org/products/p_agricultural_tractor/) A diesel engine cannot turn all of its fuel's heat into motion; no tractor figure was found.
- [Air conditioner](https://www.materialinsights.org/products/p_air_conditioner/) The ideal efficiency falls as the gap between room and outdoor temperature widens, so hot afternoons cost the most electricity.
- [Aircraft engine](https://www.materialinsights.org/products/p_aircraft_engine/) Like every heat engine, a turbofan's efficiency is bounded by its temperature ratio; ICAO links a higher pressure ratio to higher thermodynamic efficiency.
- [Cargo ship](https://www.materialinsights.org/products/p_cargo_ship/) The main diesel can turn only part of the fuel's heat into shaft work, which sets fuel use per tonne of cargo.
- [Gas turbine](https://www.materialinsights.org/products/p_gas_turbine/) Efficiency is capped by the gap between combustor and exhaust temperatures, which is why makers push the temperature up.
- [Goods vehicle](https://www.materialinsights.org/products/p_goods_vehicle/) A diesel engine cannot turn all of its fuel's heat into motion; the best engine system shown by SuperTruck II reached 55.2% brake thermal efficiency.
- [Heat pump](https://www.materialinsights.org/products/p_heat_pump/) The ratio of heat moved to work done cannot exceed the Carnot value set by the temperatures of the source and the delivered heat.
- [Heavy-duty diesel engine](https://www.materialinsights.org/products/p_heavy_duty_diesel_engine/) A heat engine cannot turn all the heat of burning into work, so the gap between combustion and exhaust temperatures caps efficiency.
- [Internal combustion engine](https://www.materialinsights.org/products/p_internal_combustion_engine/) A heat engine cannot turn all the heat of combustion into work; the gap to the cold exhaust sets the ceiling.
- [Motorcycle and scooter](https://www.materialinsights.org/products/p_motorcycle_and_scooter/) A heat engine cannot turn all the heat of burning into work, which caps petrol engine efficiency.
- [Passenger car](https://www.materialinsights.org/products/p_passenger_car/) A heat engine cannot turn all of its fuel's heat into motion; a petrol engine loses 64% to 75% of its energy
- [Refrigerator](https://www.materialinsights.org/products/p_refrigerator/) The ideal efficiency falls as the kitchen gets hotter relative to the cabinet, so hot climates cost more electricity.
- [Steam turbine](https://www.materialinsights.org/products/p_steam_turbine/) Efficiency is capped by the temperatures of the steam and the condenser, so makers push steam hotter.
 Relied on by 15

- [ST Steam turbines and thermal power plants](https://www.materialinsights.org/technologies/e_steam_turbines/) Thermal power plants are designed around the Carnot gap: hotter, higher-pressure steam and a colder condenser raise the share of heat turned into power.
- [ICV Combustion road vehicles](https://www.materialinsights.org/technologies/e_road_ice/) Car and lorry engines are heat engines, so the Carnot limit and the temperatures of combustion and exhaust bound their fuel use.
- [Shp Ship propulsion](https://www.materialinsights.org/technologies/e_marine/) Ship diesels and steam plants are heat engines, whose best possible efficiency is set by their hot and cold temperatures.
- [Rail Rail traction](https://www.materialinsights.org/technologies/e_rail_traction/) Diesel locomotives turn fuel heat into work in a heat engine bounded by the Carnot limit.
- [CHP Combined heat and power](https://www.materialinsights.org/technologies/e_chp/) Because a heat engine must reject part of its heat, combined heat and power plants put that rejected heat to use instead of wasting it.
- [Bag Bagasse and black-liquor cogeneration](https://www.materialinsights.org/technologies/e_bio_cogen/) Bagasse and black-liquor boilers drive steam turbines whose power output is bounded by the steam and exhaust temperatures, with the rest of the heat used in the mill.
- [BmC Biomass combustion and CHP](https://www.materialinsights.org/technologies/e_bio_combustion/) Biomass power plants run steam cycles whose efficiency is capped by the temperatures they work between.
- [WtE Waste-to-energy](https://www.materialinsights.org/technologies/e_waste_to_energy/) Waste plants raise steam at modest temperatures, which keeps the share of heat they can turn into power low.
- [WHR Waste-heat power (steam Rankine)](https://www.materialinsights.org/technologies/e_whr_rankine/) Waste heat is often only moderately hot, so the Carnot limit leaves only a modest share of it that can become power.
- [ORC Organic Rankine, Kalina and sCO2 cycles](https://www.materialinsights.org/technologies/e_orc/) These cycles turn low-temperature heat into power, where the small gap to the surroundings keeps the Carnot limit low.

Show 5 more

- [Trb Engine exhaust recovery](https://www.materialinsights.org/technologies/e_engine_recovery/) Exhaust heat is cooler than the combustion that made it, so the extra power a recovery cycle can draw from it is bounded by the smaller temperature gap.
- [OTEC OTEC and salinity power](https://www.materialinsights.org/technologies/e_otec/) Ocean thermal plants work between warm surface water and cold deep water, a temperature gap so small that the Carnot limit leaves only a tiny share of the heat for power.
- [CSP Concentrated solar power](https://www.materialinsights.org/technologies/e_csp/) Concentrating sunlight gives a hot source for a heat engine, and higher receiver temperatures raise the share of heat that can become power.
- [CB Carnot batteries](https://www.materialinsights.org/technologies/e_carnot/) A Carnot battery stores electricity as heat and turns it back with a heat engine, so the temperatures of the store bound how much comes back.
- [MVR Industrial heat pumps and vapour recompression](https://www.materialinsights.org/technologies/e_industrial_hp/) Industrial heat pumps work best when the temperature lift is small, as the reverse Carnot limit shows.

as of 2026-11-11

## Other sections

- [Summary](https://www.materialinsights.org/science/carnot_cycle/index.md)
- [The idea](https://www.materialinsights.org/science/carnot_cycle/sci-idea/index.md)
- [Discovery](https://www.materialinsights.org/science/carnot_cycle/sci-discovery/index.md)
