# Fracture mechanics: The idea

Source page: https://www.materialinsights.org/science/fracture_mechanics/sci-idea/

#### In plain words

The idea explained without jargon

Solids are full of tiny scratches and cracks. Stress gathers at the sharp tip of a crack, so the material there is pulled far harder than elsewhere ^[1, 3]. Griffith asked when such a crack will grow. A growing crack lets the stretched material around it relax, which frees stored energy, but it also has to make new surface, which costs energy ^[1]. Once the energy freed is larger than the energy cost, the crack runs on by itself. Longer cracks free more energy, so a solid with a long crack breaks at a lower stress ^[1, 7]. That is why real materials are much weaker than their atomic bonds suggest, and why a material's toughness, its resistance to a growing crack, matters as much as its strength ^[1, 5].

as of 2026-11-10

#### Key equation

The equation that sums it up, and what each symbol means

**Equation**
: sigma_f = sqrt(2 E gamma / (pi a))

**Symbols**
: {"sigma_f":"the stress at which the cracked plate breaks, in pascals","E":"the material's stiffness (Young's modulus), in pascals","gamma":"the energy needed to make one square metre of new surface, in joules per square metre","a":"half the length of a crack running through the plate, in metres","pi":"the number pi"}

**Note**
: This is Griffith's result for a brittle plate in plane stress as course notes write it: the breaking stress falls as one over the square root of the crack length ^[7]. For metals, Irwin wrote the same balance in terms of a stress intensity factor, and a crack grows when that factor reaches a value measured for the material, its fracture toughness ^[5, 7].

as of 2026-11-10

#### An analogy

A picture from everyday life that makes the idea easier to hold

Think of tearing a sheet of paper. Without a nick it is hard to start; with a small tear at the edge, a gentle pull runs it right across, and the longer the tear, the easier the next bit. The picture stops being true for tough metals: they bend and stretch at the tip of a crack, which soaks up much more energy than the new surface alone.

as of 2026-11-10

#### Sources

1. [The Phenomena of Rupture and Flow in Solids](https://ia802702.us.archive.org/31/items/philtrans01457975/01457975.pdf) A. A. Griffith, Philosophical Transactions of the Royal Society of London, Series A, vol. 221 (scan on the Internet Archive), 1920, pp. 163 to 198
2. [Mechanics of solids: Stress concentrations and fracture](https://www.britannica.com/science/mechanics-of-solids/Stress-concentrations-and-fracture) Encyclopaedia Britannica
3. [George R. Irwin](https://www.nationalacademies.org/read/10403/chapter/28) James W. Dally, in Memorial Tributes: Volume 10, National Academy of Engineering, 2002, pp. 146 to 153
4. [Introduction to Fracture Mechanics](https://ocw.mit.edu/courses/3-11-mechanics-of-materials-fall-1999/e5bca953e1dbd0cd0376f0f77033dc0d_MIT3_11F99_frac.pdf) David Roylance, Department of Materials Science and Engineering, MIT (MIT OpenCourseWare, 3.11 Mechanics of Materials), 2001

## Other sections

- [Summary](https://www.materialinsights.org/science/fracture_mechanics/index.md)
- [Discovery](https://www.materialinsights.org/science/fracture_mechanics/sci-discovery/index.md)
- [Technologies](https://www.materialinsights.org/science/fracture_mechanics/sci-technologies/index.md)
