# Fracture mechanics: Technologies

Source page: https://www.materialinsights.org/science/fracture_mechanics/sci-technologies/

#### Technologies

The technologies that rely on it, and how each one uses it
 Relied on by 5

- [St Knapped stone tools](https://www.materialinsights.org/technologies/knapped_stone_tools/) A blow starts a crack that runs through brittle stone along a predictable path, and controlling that crack is the craft of knapping.
- [CFR Carbon fibre composites](https://www.materialinsights.org/technologies/carbon_fibre_composites/) A crack in the resin is stopped or turned aside where it meets strong fibres, so the composite resists the spread of damage.
- [UOG Unconventional oil and gas](https://www.materialinsights.org/technologies/e_oil_gas_unconv/) Hydraulic fracturing pumps fluid into rock until the energy pushing the crack open exceeds the rock's resistance, so the crack grows and lets gas or oil flow.
- [Vst Soft body armour](https://www.materialinsights.org/technologies/aramid_body_armour/) In principle terms, it relies on fibres that are very tough, so they absorb a projectile's energy by stretching and breaking across many strands instead of letting a crack run through.
- [AGS Advanced geothermal](https://www.materialinsights.org/technologies/e_adv_geo/) Enhanced systems open cracks in tight rock with water pressure, as tested at Fenton Hill.
 Limits 24

- [Arc Masonry arch](https://www.materialinsights.org/technologies/masonry_arch/) Stone and mortar crack easily when pulled, so an arch must be shaped to stay in compression; where any part is put in tension, a crack opens.
- [Apl Powered fixed-wing aeroplane](https://www.materialinsights.org/technologies/aeroplane/) Fatigue cracks growing from holes near the cabin windows broke up Comet airliners, and airframes are now designed and inspected so that cracks are found before they reach a critical size ^[7].
- [Vst Soft body armour](https://www.materialinsights.org/technologies/aramid_body_armour/) Griffith's 1920 work showed that small flaws control when a solid breaks, which caps the strength of any fibre.
- [CFR Carbon fibre composites](https://www.materialinsights.org/technologies/carbon_fibre_composites/) The fibres are strong along their length, but cracks between layers and hidden impact damage set how far a composite part can be loaded.
- [WC Cemented carbide](https://www.materialinsights.org/technologies/cemented_carbide/) Carbide grains are brittle ceramics, so the material's toughness, its resistance to cracks, sets how hard a tool can be pushed; Griffith's 1921 theory explains strength through the flaws a material holds.
- [3DC 3D-printed construction](https://www.materialinsights.org/technologies/concrete_3d_printing/) Unreinforced printed concrete cracks easily under tension, and the joins between layers are weak planes, so reinforcement remains a key problem.
- [IFB Iron-framed building](https://www.materialinsights.org/technologies/iron_frame_building/) Cast iron is brittle and weak in tension, so a beam can crack suddenly under a pull; this limited spans and loads.
- [IHS Iron and steel ship hull](https://www.materialinsights.org/technologies/iron_hull_ship/) Welded Liberty ships cracked from square hatch corners in cold seas, showing that hull steel must resist the spread of cracks.
- [Aeroplane](https://www.materialinsights.org/products/p_aeroplane/) Repeated flight loads grow cracks in a metal or composite structure, which sets inspection and design rules.
- [Aircraft engine](https://www.materialinsights.org/products/p_aircraft_engine/) Life-limited parts such as discs and shafts carry a cycle limit and are replaced at fixed intervals.

Show 14 more

- [Bicycle](https://www.materialinsights.org/products/p_bicycle/) Frames, forks and cranks must resist cracks that grow under repeated loads.
- [Carbon fibre and composite parts](https://www.materialinsights.org/products/p_carbon_fibre_and_composite_parts/) Cracks between layers and hidden impact damage limit how far a part can be loaded.
- [Flat glass sheet](https://www.materialinsights.org/products/p_flat_glass_sheet/) Glass is brittle: flaws on its surface set how much load a pane carries before it breaks.
- [Glass container](https://www.materialinsights.org/products/p_glass_container/) Glass is brittle, and a source describes a physical boundary to lighter bottles set by its fragility.
- [Precast concrete products](https://www.materialinsights.org/products/p_precast_concrete_products/) Plain concrete cracks under tension, which is why steel or prestress is added.
- [Rolling bearing](https://www.materialinsights.org/products/p_rolling_bearing/) Repeated rolling stress starts cracks below the surface and causes flaking, which sets the bearing's fatigue life.
- [Vehicle transmission](https://www.materialinsights.org/products/p_vehicle_transmission/) Gear teeth must survive millions of load cycles without cracking at the root.
- [Wind turbine blade](https://www.materialinsights.org/products/p_wind_turbine_blade/) Cracks in the laminate and in the bond lines grow under millions of load cycles, which sets the design life.
- [Wind turbine tower](https://www.materialinsights.org/products/p_wind_turbine_tower/) Weld seams and flange bolts see millions of load cycles, so crack growth limits the life of a tower.
- [Dme Large masonry dome](https://www.materialinsights.org/technologies/pendentive_dome/) Masonry hardly resists pulling, so the spreading base of a dome cracks; iron rings were fitted to St Peter's dome by 1748 to hold it.
- [PSC Prestressed concrete](https://www.materialinsights.org/technologies/prestressed_concrete/) Concrete cracks under small tensile stress; prestressing exists to keep it out of tension.
- [Rly Railway (iron track network)](https://www.materialinsights.org/technologies/railway_track_system/) Repeated wheel loads grow fatigue cracks, such as the gauge corner cracking in rail recovered after the Hatfield crash of 2000, so rails must be inspected and replaced before a crack reaches a critical size.
- [RCo Reinforced concrete](https://www.materialinsights.org/technologies/reinforced_concrete/) Concrete cracks under small tensile stress, which is why it needs steel at all and why crack widths are checked.
- [Sky Steel-frame skyscraper](https://www.materialinsights.org/technologies/steel_frame_skyscraper/) Welded steel joints must resist cracks, and fatigue from wind and repeated loads limits how they are designed.

as of 2026-11-10

#### Sources

1. [Introduction to Fracture Mechanics](https://ocw.mit.edu/courses/3-11-mechanics-of-materials-fall-1999/e5bca953e1dbd0cd0376f0f77033dc0d_MIT3_11F99_frac.pdf) David Roylance, Department of Materials Science and Engineering, MIT (MIT OpenCourseWare, 3.11 Mechanics of Materials), 2001

## Other sections

- [Summary](https://www.materialinsights.org/science/fracture_mechanics/index.md)
- [The idea](https://www.materialinsights.org/science/fracture_mechanics/sci-idea/index.md)
- [Discovery](https://www.materialinsights.org/science/fracture_mechanics/sci-discovery/index.md)
