# Second law of thermodynamics: Technologies

Source page: https://www.materialinsights.org/science/second_law_thermodynamics/sci-technologies/

#### Technologies

The technologies that rely on it, and how each one uses it
 Limits 27

- [ICE Internal combustion engines and gensets](https://www.materialinsights.org/technologies/e_engines/) An engine cannot turn all its heat into work, so the heat it must reject leaves as hot exhaust and in the cooling water.
- [FC Fuel cells](https://www.materialinsights.org/technologies/e_fuel_cells/) Only the free energy of the reaction can become electricity; the rest of the reaction's energy must leave as heat, even in a perfect cell.
- [Elz Electrolysers](https://www.materialinsights.org/technologies/e_electrolysers/) Splitting water needs a minimum electrical work, and any voltage above what the reaction needs leaves the cell as heat.
- [DC Data centres](https://www.materialinsights.org/technologies/e_data_centres/) Erasing information must give off a minimum amount of heat, a floor set by the second law, though today's chips give off far more.
- [Crn Lifting crane](https://www.materialinsights.org/technologies/lifting_crane/) Friction in pulleys and bearings turns part of the input work into heat that cannot be turned back, so no crane returns all the effort put in.
- [CCS Carbon capture and storage](https://www.materialinsights.org/technologies/carbon_capture_storage/) Separating a dilute gas from a mixture takes a minimum amount of work, so capture always costs energy, and more for dilute streams.
- [DAC Direct air capture](https://www.materialinsights.org/technologies/direct_air_capture/) Separating carbon dioxide from air at 400 ppm takes at least about 20 kJ per mole, a floor set by the second law.
- [AGS Advanced geothermal](https://www.materialinsights.org/technologies/e_adv_geo/) Water at a couple of hundred degrees can only turn a modest share of its heat into electricity.
- [CAES Compressed-air and CO2 storage](https://www.materialinsights.org/technologies/e_caes/) Heat of compression that is cooled away cannot be fully recovered, one reason Huntorf's round-trip efficiency is estimated at about 33%.
- [CB Carnot batteries](https://www.materialinsights.org/technologies/e_carnot/) Heat flows by itself only from hot to cold, as Clausius stated in 1850; a heat pump must spend work to pump it uphill, and every irreversible step in that round trip loses energy.

Show 17 more

- [Fly Flywheels and small mechanical stores](https://www.materialinsights.org/technologies/e_flywheels/) Every bearing and drag loss turns some of the rotor's motion into heat, so a flywheel slowly runs down when left alone.
- [GSH Geothermal direct use and ground-source heat pumps](https://www.materialinsights.org/technologies/e_geo_direct/) Heat flows by itself only from hot to cold, so a heat pump must spend electricity to lift mild ground heat to room temperature.
- [GeP Geothermal power plants](https://www.materialinsights.org/technologies/e_geo_power/) Heat flows from hot to cold, and a moderately hot fluid can turn only a modest share of its heat into work.
- [H2S Hydrogen storage](https://www.materialinsights.org/technologies/e_h2_storage/) Real compressors need more than the ideal minimum work: DOE measured 1.7 to 6.4 kWh/kg for on-site compression, against a theoretical 1.36 kWh/kg to reach 700 bar.
- [LAES Liquid air storage](https://www.materialinsights.org/technologies/e_liquid_air/) Liquefying air takes more work than expansion gives back, so round-trip efficiency is about 50 to 60%, or 60 to 70% with advanced heat recovery.
- [MH Micro energy harvesting](https://www.materialinsights.org/technologies/e_micro_harvest/) Carnot efficiency is small for small temperature differences: body to cool room gives only 5.5%.
- [Ref Refining and reforming](https://www.materialinsights.org/technologies/e_refining/) Separating a mixture has a minimum energy cost; real columns use several times that minimum.
- [ICV Combustion road vehicles](https://www.materialinsights.org/technologies/e_road_ice/) Most fuel energy must leave as waste heat in the exhaust and cooling water.
- [SHS Sensible heat storage](https://www.materialinsights.org/technologies/e_sensible_heat/) Stored heat only flows from hot to cold, so a store loses value as it cools towards its surroundings and cannot give back more than a fraction as electricity.
- [Shr Shared and district heat reuse](https://www.materialinsights.org/technologies/e_shared_heat/) Heat flows on its own only from hotter to colder, so surplus heat cooler than the network water cannot enter it without a heat pump, which needs work, usually electricity, to lift it.
- [ST Steam turbines and thermal power plants](https://www.materialinsights.org/technologies/e_steam_turbines/) Some heat must always be rejected to a cold sink; in coal and nuclear steam plants about two thirds of the energy is lost this way.
- [Data-centre server](https://www.materialinsights.org/products/p_data_centre_server/) Almost all electrical power ends as low-grade heat that fans and cooling must carry away, which caps the power of a rack.
- [Heat exchanger](https://www.materialinsights.org/products/p_heat_exchanger/) Heat flows only from hot to cold, so the cold liquid can be warmed only towards the hot liquid's inlet temperature.
- [Industrial air compressor](https://www.materialinsights.org/products/p_industrial_air_compressor/) Compression work cannot be recovered once the heat is lost, so most input ends as heat.
- [Steam turbine](https://www.materialinsights.org/products/p_steam_turbine/) Some heat must be rejected to a cold sink, which is why a condenser is needed.
- [RTG Radioisotope thermoelectric generator](https://www.materialinsights.org/technologies/radioisotope_power/) Like any heat engine, an RTG can turn only part of its heat into work and must reject the rest, so most of the heat is radiated away.
- [RO Reverse osmosis desalination](https://www.materialinsights.org/technologies/reverse_osmosis_desalination/) Separating salt from water lowers entropy, so it takes a minimum amount of work, about 1 kWh per cubic metre for typical sea water.
 Relied on by 12

- [ST Steam turbines and thermal power plants](https://www.materialinsights.org/technologies/e_steam_turbines/) A steam plant must pass much of its heat to a condenser, because no engine can turn all the heat it takes in into work.
- [CB Carnot batteries](https://www.materialinsights.org/technologies/e_carnot/) Turning stored heat back into electricity is bounded by the second law, so a Carnot battery returns only part of the energy put in.
- [GeP Geothermal power plants](https://www.materialinsights.org/technologies/e_geo_power/) Geothermal fluids are only moderately hot, so the second law allows only a small share of their heat to become electricity.
- [AGS Advanced geothermal](https://www.materialinsights.org/technologies/e_adv_geo/) Hot rock deep underground gives a hotter source than shallow geothermal fluids, and the second law means a hotter source lets a larger share of the heat become electricity.
- [HP Heat pumps, air conditioning and refrigeration](https://www.materialinsights.org/technologies/e_heat_pumps/) Heat will not flow from cold to warm on its own, so a heat pump must be supplied with work to push it uphill.
- [GSH Geothermal direct use and ground-source heat pumps](https://www.materialinsights.org/technologies/e_geo_direct/) A ground-source heat pump needs work to lift heat from the cool ground to the warmer house, since heat will not flow that way by itself.
- [Bld Energy in buildings](https://www.materialinsights.org/technologies/e_buildings/) Heat flows on its own only from warm to cold, so cooling a building, or heating it with outdoor heat, needs a heat pump and work.
- [Shr Shared and district heat reuse](https://www.materialinsights.org/technologies/e_shared_heat/) Waste heat is often too cool to use directly, and raising it to a useful temperature takes a heat pump and work.
- [HX Heat exchangers and pinch integration](https://www.materialinsights.org/technologies/e_heat_exchangers/) Heat passes only from the hotter stream to the colder one, so exchangers are laid out to keep a temperature difference along their whole length.
- [Vul Vulcanisation of rubber](https://www.materialinsights.org/technologies/vulcanisation/) A stretched rubber network pulls back because its chains tend to return to more disordered, coiled shapes: its elasticity comes from entropy.
- [Air conditioner](https://www.materialinsights.org/products/p_air_conditioner/) Heat only flows from cold to warm if work is done, which is the electricity the compressor takes.
- [Refrigerator](https://www.materialinsights.org/products/p_refrigerator/) Moving heat from the cold cabinet to the warm kitchen needs work, the electricity of the compressor.

as of 2026-11-11

## Other sections

- [Summary](https://www.materialinsights.org/science/second_law_thermodynamics/index.md)
- [The idea](https://www.materialinsights.org/science/second_law_thermodynamics/sci-idea/index.md)
- [Discovery](https://www.materialinsights.org/science/second_law_thermodynamics/sci-discovery/index.md)
