# Electrical loss reduction: Science

Source page: https://www.materialinsights.org/technologies/e_electrical_recovery/tech-science/

#### Principles

The science it rests on, with why each principle matters to it
 Limited by

- [Ohm's law](https://www.materialinsights.org/science/ohms_law/) Current through a resistance always makes heat, so some loss is unavoidable; Ohm published the law in 1827 ^[7].
 Relies on

- [Electromagnetic induction](https://www.materialinsights.org/science/electromagnetic_induction/) A transformer steps voltage up and down by induction, which Faraday found in 1831 ^[8]; higher voltage means lower current and lower line loss.

as of 2026-11-12

#### Discoveries

The discoveries that made it possible: when, by whom and what was found

| Year | Who | What |
|---|---|---|
| 1827 | Georg Ohm | Published Die galvanische Kette, mathematisch bearbeitet, giving the law linking voltage and current ^[7] |
| 1831 | Michael Faraday | Induced an electric current in a second coil, the basis of the transformer ^[8] |
| 1892 | Charles Steinmetz | Ran the experiment from which the history of power theory, including reactive power, is dated ^[6] |

as of 2026-11-12

#### Physical limits

The limits nature sets, today's best and how far there is still to go

| Limit | Value | Unit | Best today | Gap |
|---|---|---|---|---|
| Power factor cannot exceed unity: at 1.0 all current does useful work | 1 | ratio | Eaton advises correcting to approximately 95% for maximum benefit ^[2] | Eaton finds that correcting to about 0.95 gives the most benefit ^[2], so the practical aim stops short of 1.0. |
| Resistive loss in any conductor is never zero | – | % | US transmission and distribution losses averaged about 5% in 2018 through 2022 ^[1] | Losses can be cut by thicker conductors, higher voltage and better transformers, but not removed. |

as of 2026-11-12

#### The science explained

The science behind it explained for a curious reader

Think of a pipe carrying beer to a bar. The bar wants beer, but some of the flow just sloshes back and forth in the pipe and never reaches a glass. That sloshing is reactive current. It does no useful work, yet it fills the pipe, and it heats the wires just as a real current does. Power factor is the share of the flow that does work ^[2]. Fitting a capacitor next to the motor is like a small tank beside the bar that takes the sloshing, so the pipe from the cellar carries only the beer. Because heating in a wire grows with the square of the current, which follows from Ohm's law of 1827 ^[7], even a modest cut in current gives a big cut in loss: the Eaton formula puts the gain from raising power factor from 0.8 to 0.95 at roughly 29% of the losses (calculated) ^[2]. Transformers work by induction, found in 1831 ^[8], and lose some power in their cores.

as of 2026-11-12

#### Sources

1. [How much electricity is lost in electricity transmission and distribution in the United States? (FAQ)](https://www.eia.gov/tools/faqs/faq.php?id=105) US EIA, 2023
2. [Power factor correction: A guide for the plant engineer](https://www.eaton.com/content/dam/eaton/products/low-voltage-power-distribution-controls-systems/power-factor-corrections/portfolio/eaton-pfc-guide-plant-engineer-SA02607001E.pdf) Eaton, 2024
3. [From Steinmetz to currents' physical components (CPC): History of power theory development (Czarnecki)](https://repository.lsu.edu/eecs_pubs/441) ICATE 2016 proceedings, via LSU Scholarly Repository, 2016
4. [Ohm's Law](https://ethw.org/Ohm%27s_Law) Engineering and Technology History Wiki (IEEE)
5. [Michael Faraday's ring-coil apparatus](https://rigb.org/node/143) Royal Institution

## Other sections

- [Summary](https://www.materialinsights.org/technologies/e_electrical_recovery/index.md)
- [Overview](https://www.materialinsights.org/technologies/e_electrical_recovery/overview/index.md)
- [Correlation](https://www.materialinsights.org/technologies/e_electrical_recovery/correlation/index.md)
- [Science and thermodynamics](https://www.materialinsights.org/technologies/e_electrical_recovery/rc-sci/index.md)
- [Engineering and integration](https://www.materialinsights.org/technologies/e_electrical_recovery/rc-eng/index.md)
- [Economics and contracts](https://www.materialinsights.org/technologies/e_electrical_recovery/rc-econ/index.md)
- [Impact and additionality](https://www.materialinsights.org/technologies/e_electrical_recovery/rc-impact/index.md)
- [What to track](https://www.materialinsights.org/technologies/e_electrical_recovery/tracking/index.md)
- [Overview](https://www.materialinsights.org/technologies/e_electrical_recovery/tech-overview/index.md)
- [Evolution](https://www.materialinsights.org/technologies/e_electrical_recovery/tech-evolution/index.md)
- [Materials](https://www.materialinsights.org/technologies/e_electrical_recovery/tech-materials/index.md)
- [Energy footprint](https://www.materialinsights.org/technologies/e_electrical_recovery/tech-energy-footprint/index.md)
- [Industries](https://www.materialinsights.org/technologies/e_electrical_recovery/tech-industries/index.md)
- [Relationships](https://www.materialinsights.org/technologies/e_electrical_recovery/links/index.md)
