# Flywheels and small mechanical stores: Science

Source page: https://www.materialinsights.org/technologies/e_flywheels/tech-science/

#### Principles

The science it rests on, with why each principle matters to it
 Relies on

- [Newton's laws of motion](https://www.materialinsights.org/science/newtons_laws/) A spinning rotor keeps turning until a torque slows it, the inertia set out in Newton's Principia of 1687 ^[8], so it holds its energy as motion.
 Limited by

- [Second law of thermodynamics](https://www.materialinsights.org/science/second_law_thermodynamics/) Every bearing and drag loss turns some of the rotor's motion into heat, so a flywheel slowly runs down when left alone ^[4].

as of 2026-11-12

#### Discoveries

The discoveries that made it possible: when, by whom and what was found

| Year | Who | What |
|---|---|---|
| 1687 | Isaac Newton | Published the Principia, setting out the laws of motion ^[8] |
| 1829 | Gaspard-Gustave de Coriolis | Published on the calculation of the work done by machines; he gave 'work' and 'kinetic energy' their present scientific meaning ^[9] |
| 1835 | Gaspard-Gustave de Coriolis | Showed how the laws of motion apply in a rotating frame by adding the Coriolis acceleration ^[9] |

as of 2026-11-12

#### Physical limits

The limits nature sets, today's best and how far there is still to go

| Limit | Value | Unit | Gap |
|---|---|---|---|
| Energy per kilogram of rotor is capped by the material's strength divided by its density, times a shape factor (E/m = K strength/density); for a hollow carbon fibre rim, about 0.3 times 600 kNm/kg | 50 | Wh/kg | Calculated ceiling; real rotors run below it to keep a safety margin and because the speed range used is limited to between a half and a third of maximum at the low end ^[4] |

Estimate · as of 2026-11-12. Calculated from the review's figures [4]: 0.3 x 600 kNm/kg = 180 kJ/kg, about 50 Wh/kg. For wrought steel, about 75 kNm/kg, the same sum gives far less.

#### The science explained

The science behind it explained for a curious reader

A potter's wheel keeps turning after a push because a spinning mass resists any change to its motion. A flywheel store uses this on purpose. The energy of a spinning rotor grows with its mass and with the square of its speed, so doubling the speed stores four times as much. That points to very fast rotors, but speed is limited by strength: the faster the rim spins, the harder it pulls itself apart. The best a material can do is set by its strength divided by its density. Carbon fibre composites, developed in the 1970s, are several times better than steel by this measure ^[4], which is why modern rotors are made of them. To keep the stored motion from leaking away, rotors spin in a vacuum on magnetic bearings, but small losses remain, so flywheels hold energy for minutes rather than days ^[4].

as of 2026-11-12

#### Sources

1. [The Status and Future of Flywheel Energy Storage](https://openaccess.city.ac.uk/id/eprint/22226/3/The%20status%20and%20future%20of%20flywheel%20energy%20storage-May19.pdf) Joule 3(6), pp. 1394 to 1399 (K. R. Pullen), accepted manuscript at City Research Online, City, University of London, 2019
2. [This Month in Physics History: July 5, 1687: Publication of Sir Isaac Newton's Principia](https://aps.org/publications/apsnews/200007/history.cfm) American Physical Society, APS News, 2000
3. [Gaspard-Gustave de Coriolis, biography](https://mathshistory.st-andrews.ac.uk/Biographies/Coriolis/) MacTutor History of Mathematics, University of St Andrews (J. J. O'Connor and E. F. Robertson)

## Other sections

- [Summary](https://www.materialinsights.org/technologies/e_flywheels/index.md)
- [Overview](https://www.materialinsights.org/technologies/e_flywheels/overview/index.md)
- [Correlation](https://www.materialinsights.org/technologies/e_flywheels/correlation/index.md)
- [Science and technology](https://www.materialinsights.org/technologies/e_flywheels/sg-sci/index.md)
- [Engineering and performance](https://www.materialinsights.org/technologies/e_flywheels/sg-eng/index.md)
- [Economics](https://www.materialinsights.org/technologies/e_flywheels/sg-econ/index.md)
- [Impact and additionality](https://www.materialinsights.org/technologies/e_flywheels/sg-impact/index.md)
- [What to track](https://www.materialinsights.org/technologies/e_flywheels/tracking/index.md)
- [Overview](https://www.materialinsights.org/technologies/e_flywheels/tech-overview/index.md)
- [Evolution](https://www.materialinsights.org/technologies/e_flywheels/tech-evolution/index.md)
- [Materials](https://www.materialinsights.org/technologies/e_flywheels/tech-materials/index.md)
- [Energy footprint](https://www.materialinsights.org/technologies/e_flywheels/tech-energy-footprint/index.md)
- [Industries](https://www.materialinsights.org/technologies/e_flywheels/tech-industries/index.md)
- [Relationships](https://www.materialinsights.org/technologies/e_flywheels/links/index.md)
