# Mechanical power transmission: Overview

Source page: https://www.materialinsights.org/technologies/e_mechanical_transmission/tech-overview/

#### What it does

The job the technology does for people, in a short paragraph

Mechanical power transmission carries the work of one engine to many machines. Mills from 1771 drove rows of spinning frames from a single water wheel through gears, shafts and belts ^[1]. Cities later piped power itself: London's hydraulic mains ran 180 miles at their peak ^[2]. Today about a third of industrial and commercial electric motors drive their loads through belts ^[4], and US fluid power, hydraulics and pneumatics, used 2.0 to 2.9 quads of energy in 2008 ^[3].

as of 2026-11-12

#### How it works

The working principle in plain words, step by step

There are two families. Rigid links carry power as rotation: a shaft turns, gears of different sizes trade speed for turning force, and belts or ropes carry the rotation across a room. In early mills one water wheel turned a line shaft running the length of the building, and belts took power down to each machine ^[1]. Fluid links carry power as pressure instead. A pump pushes water or oil into pipes; at the far end the pressure drives a ram, a lift or a motor. London's hydraulic company did this with a citywide network at a nominal 800 psi ^[2]. Compressed air works in the same way, but air is springy and leaks easily, so it is the least efficient: leaks can waste 20 to 30% of a compressor's output ^[5].

as of 2026-11-12

#### Key figures

The handful of numbers that size it up, each with its unit, year and source

| Figure | Value | Unit | Year | Source |
|---|---|---|---|---|
| Energy used by US fluid power systems, upper end of 2.0 to 2.9 | 2.9 | quads per year | 2008 | ^[3] |
| Average efficiency of US fluid power systems | 22 | % | 2008 | ^[3] |
| Efficiency of synchronous (toothed) belt drives | 98 | % | 2012 | ^[4] |
| Share of a compressor's output that leaks can waste, upper end | 30 | % | 2026 | ^[5] |
| Length of London's hydraulic power mains at their peak | 180 | miles | – | ^[2] |

as of 2026-11-12. The ORNL figures are for 2008 [3]; the 22% is the study's weighted average across all segments, built on the same 2008-based estimates. The belt and leak figures are engineering rules of thumb, dated by their tip sheet (2012) and fact sheet (2026) [4][5]. The Science Museum gives no year for London's peak network [2].

#### Where it is used

The main places and products the technology is found in

- Belt drives on fans, pumps and machines, used by about a third of industrial and commercial electric motors ^[4]
- Industrial and mobile hydraulics, from presses to off-road machines ^[3]
- Factory compressed-air systems ^[5]
- Historic city hydraulic networks powering lifts, cranes, theatre machinery and the backup mechanism of Tower Bridge ^[2]

as of 2026-11-12

#### Scale today

How much of it there is now: units in use, made each year and who uses it

**Installed**
: About one third of industrial and commercial electric motors use belt drives ^[4]

**Users**
: US fluid power used 2.0 to 2.9 quads in 2008, emitting 310 to 380 million tonnes of CO2 ^[3]

**Unit**
: quads per year

**Year**
: 2008

**Note**
: Industrial hydraulics used about 1.1 quads, mobile hydraulics 0.4 to 1.3 and pneumatics about 0.5 quads a year ^[3]. No world total was found.

as of 2026-11-12

#### Sources

1. [History & Development](https://www.derwentvalleymills.org/discover/derwent-valley-mills-history/derwent-valley-mills-history-development/) Derwent Valley Mills World Heritage Site
2. [London Hydraulic Power Company](https://collection.sciencemuseumgroup.org.uk/people/ap28550/london-hydraulic-power-company) Science Museum Group Collection, 2025
3. [Estimating the Impact (Energy, Emissions and Economics) of the U.S. Fluid Power Industry (ORNL/TM-2011/14), Love, Lanke and Alles](https://info.ornl.gov/sites/publications/files/pub28014.pdf) Oak Ridge National Laboratory, 2012
4. [Replace V-Belts with Notched or Synchronous Belt Drives](https://www.nrel.gov/docs/fy13osti/56012.pdf) US Department of Energy, Advanced Manufacturing Office (Motor Systems Tip Sheet), via NREL, 2012
5. [Compressed Air System Leaks (Improving Compressed Air System Performance, Fact Sheet #7, Rev. 1)](https://www.compressedairchallenge.org/data/sites/1/media/library/factsheets2026/fact-sheet-7-compressed-air-system-leaks_updated2026.pdf) Compressed Air Challenge, 2026

## Other sections

- [Summary](https://www.materialinsights.org/technologies/e_mechanical_transmission/index.md)
- [Overview](https://www.materialinsights.org/technologies/e_mechanical_transmission/overview/index.md)
- [Correlation](https://www.materialinsights.org/technologies/e_mechanical_transmission/correlation/index.md)
- [How it works](https://www.materialinsights.org/technologies/e_mechanical_transmission/explain/index.md)
- [Efficiency and losses](https://www.materialinsights.org/technologies/e_mechanical_transmission/efficiency/index.md)
- [Technology advances](https://www.materialinsights.org/technologies/e_mechanical_transmission/advances/index.md)
- [Value chain](https://www.materialinsights.org/technologies/e_mechanical_transmission/valuechain/index.md)
- [Geopolitics and regulation](https://www.materialinsights.org/technologies/e_mechanical_transmission/geopolitics/index.md)
- [Unit economics](https://www.materialinsights.org/technologies/e_mechanical_transmission/economics/index.md)
- [Impact on the biosphere](https://www.materialinsights.org/technologies/e_mechanical_transmission/biosphere/index.md)
- [Science](https://www.materialinsights.org/technologies/e_mechanical_transmission/tech-science/index.md)
- [Evolution](https://www.materialinsights.org/technologies/e_mechanical_transmission/tech-evolution/index.md)
- [Materials](https://www.materialinsights.org/technologies/e_mechanical_transmission/tech-materials/index.md)
- [Energy footprint](https://www.materialinsights.org/technologies/e_mechanical_transmission/tech-energy-footprint/index.md)
- [Industries](https://www.materialinsights.org/technologies/e_mechanical_transmission/tech-industries/index.md)
- [Relationships](https://www.materialinsights.org/technologies/e_mechanical_transmission/links/index.md)
