# Injection moulding: Energy footprint

Source page: https://www.materialinsights.org/technologies/injection_moulding/tech-energy-footprint/

#### Energy in use

The energy it uses or converts while it works, and how efficiently

**Consumption**
: Electricity for heaters, the screw drive and the clamp; often water for mould cooling

**Conversion**
: Electrical energy to heat that melts the plastic, then removed again by the cooled mould

**Note**
: No source opened gives energy per kilogram of moulded plastic.

as of 2026-11-11

#### Energy links

The energy sources and technologies it uses, holds, converts, loses or gets back
 Consumes

- [El Electricity](https://www.materialinsights.org/energy/electricity/) Heaters, motors and hydraulic pumps of the moulding machine run on electricity.
 Loses

- [Ht Heat](https://www.materialinsights.org/energy/heat/) The heat used to melt the plastic is carried away by the mould's cooling water.

as of 2026-11-11

## Other sections

- [Summary](https://www.materialinsights.org/technologies/injection_moulding/index.md)
- [Overview](https://www.materialinsights.org/technologies/injection_moulding/tech-overview/index.md)
- [Science](https://www.materialinsights.org/technologies/injection_moulding/tech-science/index.md)
- [Evolution](https://www.materialinsights.org/technologies/injection_moulding/tech-evolution/index.md)
- [Materials](https://www.materialinsights.org/technologies/injection_moulding/tech-materials/index.md)
- [Industries](https://www.materialinsights.org/technologies/injection_moulding/tech-industries/index.md)
