# Injection moulding: Materials

Source page: https://www.materialinsights.org/technologies/injection_moulding/tech-materials/

#### Materials it needs

The commodities and chemicals it needs per unit, its share of each one's demand and how critical each is
 Processes 6

- [PP Polypropylene](https://www.materialinsights.org/chemicals/polypropylene/) criticality low A common moulding plastic for caps, crates and car parts.
- [LLDPE Polyethylene (LDPE, LLDPE)](https://www.materialinsights.org/chemicals/polyethylene/) criticality low One of the commonest moulding thermoplastics ^[3], used for lids, containers and household goods.
- [ABS ABS](https://www.materialinsights.org/chemicals/abs/) criticality low A tough plastic moulded into toy bricks and appliance housings.
- [PS Polystyrene and EPS](https://www.materialinsights.org/chemicals/polystyrene/) criticality low A common moulding thermoplastic ^[3], used for cutlery, model kits and packaging.
- [PC Polycarbonate](https://www.materialinsights.org/chemicals/polycarbonate/) criticality low Moulded into clear, impact-resistant parts such as lenses and covers.
- [PA Nylon (PA6, PA66)](https://www.materialinsights.org/chemicals/nylon/) criticality low Polyamide is a common moulding thermoplastic ^[3], used for gears, clips and parts that must resist heat and wear.
 Needs

- [St Steel](https://www.materialinsights.org/commodities/steel/) criticality low Production moulds are usually cut from hardened tool steel so they survive many cycles; short-run moulds may be aluminium ^[11].

as of 2026-11-11. No source gives material amounts per part; criticality is the writer's judgement: the plastics are made in huge amounts from oil and gas and the mould steels are widely available.

#### Critical materials

The materials whose supply could hold it back

- No material is likely to hold injection moulding back: the main plastics and mould steels are made in very large amounts.
- Fossil feedstocks: plastics are made mostly from oil and gas, and only 15.4% of production in 2024 was post-consumer recycled, bio-based or carbon-captured ^[5].

as of 2026-11-11

#### Sources

1. [Injection moulding](https://www.modip.ac.uk/plastics/manufacturing-processes/injection-moulding) Museum of Design in Plastics, Arts University Bournemouth
2. [Plastics the Fast Facts 2025](https://plasticseurope.org/de/wp-content/uploads/sites/3/2025/10/PE_TheFacts_25_digital-A4.pdf) Plastics Europe (October 2025), 2025
3. [Leveraging low-volume injection moulding](https://www.protolabs.com/en-gb/resources/design-tips/leveraging-low-volume-injection-moulding/) Protolabs

## Other sections

- [Summary](https://www.materialinsights.org/technologies/injection_moulding/index.md)
- [Overview](https://www.materialinsights.org/technologies/injection_moulding/tech-overview/index.md)
- [Science](https://www.materialinsights.org/technologies/injection_moulding/tech-science/index.md)
- [Evolution](https://www.materialinsights.org/technologies/injection_moulding/tech-evolution/index.md)
- [Energy footprint](https://www.materialinsights.org/technologies/injection_moulding/tech-energy-footprint/index.md)
- [Industries](https://www.materialinsights.org/technologies/injection_moulding/tech-industries/index.md)
