Atomic layer deposition: Science
Principles
The science it rests on, with why each principle matters to it
Relies on- Surface chemistry and adsorption Each pulse reacts only with the sites on the surface and stops when they are used up [2], the one-particle-per-site picture of surfaces Langmuir proposed in 1917 [7].
- Quantum tunnelling Below about 2 nm, charge carriers tunnel through a silicon dioxide gate insulator and leakage rises sharply [6]; chip makers answered with thicker hafnium-based insulators, for which ALD is critical [6].
as of 2026-11-11
Discoveries
The discoveries that made it possible: when, by whom and what was found
| Year | Who | What |
|---|---|---|
| 1917 | Irving Langmuir | Proposed that a surface is like a chessboard where each square holds one atom or molecule [7] |
| 1974 | Tuomo Suntola and his group | Grew zinc sulphide films by alternating, saturating gas-solid reactions [1] |
as of 2026-11-11
Physical limits
The limits nature sets, today's best and how far there is still to go
| Limit | Value | Unit | Best today | Gap |
|---|---|---|---|---|
| Growth per cycle: one self-terminating cycle adds at most a monolayer | – | monolayer per cycle | Typically a fraction of a monolayer per cycle [2] | None to close: the cap is what gives ALD its exact thickness control, at the cost of speed |
| Leakage through a silicon dioxide gate insulator | 2 | nm | Hafnium-based insulators, grown by ALD, in mass production since 2007 [3, 6] | A material with a higher dielectric constant can be thicker for the same effect, so it leaks less |
as of 2026-11-11
The science explained
The science behind it explained for a curious reader
Think of a chessboard where each square can hold just one piece, the picture of a surface Langmuir proposed in 1917 [7]. Pour gas A over the board: its molecules fill every free square, and once the board is full, the rest simply bounce off [2]. Sweep away the extras. Now pour gas B: it reacts only with the pieces already sitting there, leaving a fresh board with new squares to fill. One round of A, sweep, B, sweep adds part of a single atomic layer [2]. Nothing depends on how long you pour or how unevenly the gas flows, because each step stops by itself. That is why ALD can coat deep trenches and complex shapes with a film of exactly the same thickness everywhere.
as of 2026-11-11
Sources
- ALD: Exhibition: 40 Years of ALD in Finland - Photos, Stories Aalto University, Aalto OpenLearning
- ALD: Brief introduction to ALD Aalto University, Aalto OpenLearning
- ESA researching atomic layering technique whose inventor won technology's 'Nobel' prize European Space Agency
- Semiconductor industry switches to hafnium-based transistors Jermey N. A. Matthews, Physics Today, vol. 61, no. 2, 2008
- Irving Langmuir - Facts NobelPrize.org