Material Insights · Understanding the Material World

Bayer alumina process: Overview

What it does

The job the technology does for people, in a short paragraph

The Bayer process turns bauxite ore into alumina, aluminium oxide, the raw material of aluminium metal [1]. Karl Josef Bayer patented it in 1887 [1], and the first plant was set up at Gardanne in 1893 [4][10]. More than 90% of alumina is smelted into aluminium [1]. In 2025 the world's refineries made about 150 million t, China 93 million t of it [3].

as of 2026-11-12

How it works

The working principle in plain words, step by step

Bauxite is crushed and washed into a slurry [1]. In the digestion step it is mixed with hot caustic soda, which dissolves the aluminium-bearing minerals and leaves the rest of the ore undissolved [1]. The undissolved part settles as red mud and is filtered off [1]. The clear liquor, a supersaturated solution of sodium aluminate, is then cooled, and aluminium hydroxide crystallises out [1]. The spent liquor goes back to digestion, so the caustic soda is used again and again [1]. Finally the hydroxide is roasted at high temperature, driving off water and leaving white alumina powder [1]. It takes two to three tonnes of bauxite to make one tonne of alumina [1].

as of 2026-11-12

Key figures

The handful of numbers that size it up, each with its unit, year and source

FigureValueUnitYearSource
World alumina refinery production150million t2025[3]
World bauxite mine production, excluding the United States440million t2025[3]
Bauxite needed per tonne of alumina (upper end of two to three)3t/t2025[1]
Bauxite residue left per tonne of alumina1.2t/t2022[2]
Fuel used by the world's alumina refineries1.19 millionTJ2024[7]

as of 2026-11-12. The 2025 USGS figures are estimates, and the bauxite total excludes US production (footnote 8) [3]. The bauxite ratio is from an IAI page that shows only its 2025 copyright year, not a data year [1]; the residue ratio is quoted from IAI guidance of 2022, its publication year [2]. The fuel total is IAI data as reported by AlCircle, as the IAI's own page loads its figures interactively; divided by the 138.59 million t of alumina reported with it, it gives about 8.6 GJ per tonne (calculated) [7].

Where it is used

The main places and products the technology is found in

  • Alumina for aluminium smelters, more than 90% of world supply [1]
  • Non-metallurgical alumina products, about 30% of US output (calculated from the 70% that went to smelters) [3]
  • Gallium recovery from bauxite processing, the main world source of the metal [8]
  • Alumina for the textile industry, its first purpose in 1887 [6]

as of 2026-11-12

Scale today

How much of it there is now: units in use, made each year and who uses it

Made per year
About 150 million t of alumina in 2025 [3]
Unit
t of alumina
Year
2025
Note
Counts alumina from all refineries, as USGS reports it (2025 estimate); bauxite is the only commercial raw material for alumina in the United States [3].

as of 2026-11-12

Sources

  1. Refining: Refining Process - The Aluminium Story International Aluminium Institute
  2. Bauxite Residue International Aluminium Institute
  3. Mineral Commodity Summaries 2026: Bauxite and Alumina USGS, 2026
  4. Alteo Gardanne Refinery: 130 Years of Adaptation to Meet the Dual Challenges of Environmental Protection and Added Value (G. Bastien and L. Guillaumont) ICSOBA, Proceedings of the 42nd International ICSOBA Conference, Lyon, 2024
  5. March 23, 1821: Bauxite Discovered EARTH Magazine, American Geosciences Institute (Nate Burgess), 2015
  6. Alumina refining fuel consumption hit 1 million TJ in 2024 - Fuel mix transition weighs in AlCircle (reporting International Aluminium Institute data; the page shows no date)
  7. Mineral Commodity Summaries 2026: Gallium USGS, 2026
  8. Aluminium: production de l'alumine Encyclopædia Universalis (Robert Gadeau and Robert Guillot)