Combined heat and power: Overview
What it does
The job the technology does for people, in a short paragraph
Combined heat and power, or cogeneration, makes electricity and puts the leftover heat to work in the same plant, instead of letting it escape. Histories of CHP date it to Edison's Pearl Street Station in 1882 [1]. A CHP plant can turn 75 to 80% of its fuel into useful energy, against 35 to 37% for the average power-only plant [3]. In 2000 CHP made about 10% of the world's electricity [2].
as of 2026-11-12
How it works
The working principle in plain words, step by step
Any engine that burns fuel to make power must throw away part of the heat, a limit set by the laws of heat. A power-only plant sends that heat up a chimney or into a cooling tower. A CHP plant captures it instead. A gas engine, gas turbine or steam turbine drives a generator, and a heat exchanger takes heat from the exhaust or from the steam as it leaves the turbine. That heat makes hot water or steam for a factory process, a building or a district heating network. Because the plant sits close to the user, little heat is lost on the way. The result is more useful energy from each unit of fuel: CHP with heat recapture can reach 80% efficiency [2].
as of 2026-11-12
Key figures
The handful of numbers that size it up, each with its unit, year and source
| Figure | Value | Unit | Year | Source |
|---|---|---|---|---|
| Fuel turned into useful energy by CHP plants, top of range | 80 | % | 2009 | [3] |
| Average efficiency of power-only fossil generation worldwide, top of range | 37 | % | 2009 | [3] |
| Share of world electricity made by CHP | 10 | % | 2000 | [2] |
| Share of European Union electricity made by CHP | 11 | % | 2017 | [2] |
| CHP capacity in use in the United States, nearly | 80 | GW | 2023 | [4] |
| Technical potential for more CHP in the United States, at over 291,000 sites | 240 | GW | 2016 | [2] |
as of 2026-11-12. The two IEA figures carry 2009, the report's publication year; it gives no data year. The US capacity is from Oak Ridge's page, whose installation data run to 31 December 2023 [4]. The world share was about 14% in 1990 [2]. The 240 GW is the 2016 Department of Energy study's estimate of what could be installed, not what exists [2].
Where it is used
The main places and products the technology is found in
- Paper mills, food processors and chemical plants that need a lot of process steam [2]
- Power companies that sell steam to nearby customers for space heating or industry [2]
- District heating schemes, as in Denmark, where policy has encouraged CHP [3]
as of 2026-11-12
Scale today
How much of it there is now: units in use, made each year and who uses it
- Installed
- Nearly 80 GW at more than 4,000 facilities in the United States [4]
- Users
- About 10% of world electricity came from CHP in 2000, and 11% of EU electricity in 2017 [2]
- Unit
- GW and share of electricity
- Year
- 2023
- Note
- No source opened gives a world capacity or a current world share. The US capacity counts installations to the end of 2023 [4]; the shares are for 2000 and 2017 [2].
as of 2026-11-12
Sources
- A brief history of CHP development in the United States ACEEE (American Council for an Energy-Efficient Economy), 2016
- Combined Heat and Power: A Sleeping Giant May Be Waking POWER magazine, 2019
- Cogeneration and District Energy: Sustainable energy technologies for today and tomorrow International Energy Agency, 2009
- Frequently Asked Questions (CHP eCatalog) Oak Ridge National Laboratory