Electrolysers: Science
Principles
The science it rests on, with why each principle matters to it
Relies on- Faraday's laws of electrolysis Faraday's laws of electrolysis, worked out from 1833, tie the amount of hydrogen made to the electric charge passed [6].
- The electrochemical cell An electrolyser is a cell driven backwards: outside power forces the reaction that a fuel cell runs forwards.
- Catalysis Catalysts on the electrodes speed up the slow oxygen reaction, so less extra voltage is wasted.
- Second law of thermodynamics Splitting water needs a minimum electrical work; any voltage above what the reaction needs leaves the cell as heat.
as of 2026-11-10
Discoveries
The discoveries that made it possible: when, by whom and what was found
| Year | Who | What |
|---|---|---|
| 1789 | Adriaan Paets van Troostwijk and Johan Rudolph Deiman | Water split into gases by electricity [1] |
| 1800 | William Nicholson and Anthony Carlisle | Electrolysis: a steady current produces hydrogen and oxygen from water [1] |
| 1833 | Michael Faraday | The laws of electrolysis, worked out between 1833 and 1836 [6] |
as of 2026-11-10
Physical limits
The limits nature sets, today's best and how far there is still to go
| Limit | Value | Unit | Best today | Gap |
|---|---|---|---|---|
| Thermoneutral cell voltage, above which extra voltage becomes waste heat | 1.48 | V | PEM stack at 51 kWh/kg, 65% of the hydrogen's lower heating value, 2022 [3] | The DOE's ultimate stack target is 43 kWh/kg, 77% [3]; with heat from outside a cell can split water from about 1.23 V [7] |
as of 2026-11-10
The science explained
The science behind it explained for a curious reader
Splitting water is like pushing a ball uphill. Hydrogen and oxygen hold more chemical energy than the water they came from, and the electric current supplies the difference. Faraday found that the amount of gas made depends only on how much charge flows [6], so every kilogram of hydrogen needs the same number of electrons, whatever the machine. The energy used is that charge times the cell voltage. In principle a cell can work at between about 1.23 and 1.48 volts, depending on how much heat it draws from around it [7]. Real cells run higher, because the reactions are slow and the parts resist the current, and the extra voltage turns into heat. That is why a 2022 PEM system needed 55 kWh for each kilogram, against a long-term target of 46 [3].
as of 2026-11-10
Sources
- Introduction to Liquid Alkaline Electrolysis (Marcelo Carmo, Nel Hydrogen; DOE Hydrogen Energy Earthshot experts meeting on advanced liquid alkaline water electrolysis) US Department of Energy, 2022
- Technical Targets for Proton Exchange Membrane Electrolysis US Department of Energy, Hydrogen and Fuel Cell Technologies Office, 2023
- The extraordinary impact of Michael Faraday on chemistry and related subjects (J. M. Thomas) Chemical Communications, Royal Society of Chemistry, 2017
- Proton exchange membrane electrolysis Wikipedia