Material Insights · Understanding the Material World

Transformers and power electronics: Science

Principles

The science it rests on, with why each principle matters to it

Relies on
  • Electromagnetic induction A changing magnetic field in the core induces the voltage in the second winding of a transformer.
  • Band theory of solids Semiconductor switches work because the band gap of silicon or silicon carbide lets a small control signal turn conduction on and off.
  • The p-n junction Thyristors, diodes and IGBTs are stacks of p-n junctions; the first thyristor was a p-n-p-n device [2].
Limited by
  • Ferromagnetism and magnetic domains Iron cores carry the field, but magnetising them every cycle wastes energy even with no load [3].
  • Ohm's law Winding and switch resistance turn part of the current into heat, rising with the square of the current.

as of 2026-11-11

Discoveries

The discoveries that made it possible: when, by whom and what was found

YearWhoWhat
1820Hans Christian OerstedFound that an electric current makes a magnetic field [8]
1831Michael FaradayDiscovered electromagnetic induction, the effect every transformer uses [1]
1957General ElectricIntroduced the silicon-controlled rectifier, a p-n-p-n silicon switch for large currents [2]

as of 2026-11-11

Physical limits

The limits nature sets, today's best and how far there is still to go

LimitUnitBest todayGap
No thermodynamic ceiling: electricity in, electricity out%Transformers typically above 99% efficient [3]Under 1%, lost in winding resistance and core magnetisation
Core (no-load) loss, present whenever the transformer is energisedW1,747 W with high-permeability steel against 2,782 W with standard steel, 2,500 kVA unit [3]Set by the magnetic properties of the core steel

as of 2026-11-11

The science explained

The science behind it explained for a curious reader

Picture two gears of different sizes meshed together. The small one spins fast with little force, the large one slowly with more force, and the power passed between them is the same. A transformer does this for electricity: the coil with more turns gives a higher voltage and a smaller current. The link between the coils is a magnetic field in the iron core that must keep changing, which is why transformers only work on alternating current. Faraday found this induction in 1831 [1]. Power electronics add a fast switch. Turning a current on and off thousands of times a second and varying how long each pulse lasts lets a circuit shape the average into DC, AC of any frequency or a new voltage. The silicon-controlled rectifier of 1957 made such switching practical for large currents [2].

as of 2026-11-11

Sources

  1. Centenary of the Transformer (P. Asztalos) Periodica Polytechnica Electrical Engineering, Budapest University of Technology and Economics
  2. General Electric Device That Revolutionized Electrical Machines Is Now an IEEE Milestone IEEE Spectrum (The Institute), 2019
  3. Transforming revenue: ABB's technology cuts transformer losses (ABB Review 2/2015; vendor case) ABB, 2015
  4. The invention of the electric motor 1800-1854 Karlsruhe Institute of Technology, Elektrotechnisches Institut