Material Insights · Understanding the Material World

Superconducting magnetic storage: Overview

What it does

The job the technology does for people, in a short paragraph

SMES stores electricity as a magnetic field in a coil that has no electrical resistance, and gives it back within milliseconds to seconds [1]. It suits jobs that need a lot of power briefly, such as steadying a grid after a fault, rather than storing energy for hours [1]. The idea appeared in 1970 [1], a 30 MJ unit ran on a US grid from 1983 [2][3], and six units guarded a Wisconsin grid from 2000 [1]. It remains a niche technology because of its high cost [1].

as of 2026-11-12

How it works

The working principle in plain words, step by step

A coil of superconducting wire is cooled, usually with liquid helium, until its resistance vanishes [1]. A power converter, the electronics that switch between alternating and direct current, drives a current into the coil. With no resistance the current keeps circulating, and the energy sits in the magnetic field it creates. When the grid needs power, the converter draws the current out and feeds it back as alternating current, very quickly, in milliseconds to seconds when protecting against voltage sags [1]. The amount stored rises with the square of the current and with the coil's size. The magnetic forces push the windings apart, so a strong structure must hold them, and that structure, not the superconductor, limits how much energy each kilogram can store [1].

as of 2026-11-12

Key figures

The handful of numbers that size it up, each with its unit, year and source

FigureValueUnitYearSource
Energy of the Bonneville Power Administration test unit (8.4 kWh)30MJ1983[2]
Converter rating of the Bonneville unit10MW1983[2]
Energy conversion efficiency, greater than95%2008[1]
Practical energy density, of the order of10kJ/kg2008[1]
Distributed SMES units installed in northern Wisconsin6units2000[1]

as of 2026-11-12. Efficiency and energy density are from a 2008 review [1]; the year shown is the review's.

Where it is used

The main places and products the technology is found in

  • Damping power swings on long transmission links, as on the Pacific AC Intertie in 1983 [2]
  • Voltage support on weak grids, as on Wisconsin's Northern Loop [4]
  • Units built in Japan, such as a 7 MJ, 5 MW coil of 2003 [1]
  • Short, high-power bursts where batteries respond too slowly [1]

as of 2026-11-12

Scale today

How much of it there is now: units in use, made each year and who uses it

Installed
A handful of demonstration and utility units; six distributed units in Wisconsin from 2000 [1]
Unit
units
Year
2008
Note
No source opened gives a current world count of SMES in service; the 2008 review describes the technology as held back by its high cost [1].

as of 2026-11-12

Sources

  1. Superconducting Magnetic Energy Storage: Status and Perspective (IEEE/CSC and ESAS European Superconductivity News Forum, No. 3) Pascal Tixador, Grenoble INP and Institut Néel, 2008
  2. Tests of the 30-MJ superconducting magnetic-energy storage unit (LA-UR-83-2516) Los Alamos National Laboratory and Bonneville Power Administration, via OSTI
  3. Superconducting Magnetic Energy Storage (SMES) Program. Progress report, January 1 to December 31, 1983 (LA-10050-PR) Los Alamos National Laboratory, via OSTI
  4. D-SMES for Wisconsin (historical trade article, 1999) Modern Power Systems, 1999