Wave energy converters: Efficiency
Why nobody agrees how efficient a wave machine is
Wave devices are judged by how much of the wave power arriving across their width they absorb (hydrodynamic efficiency), then by how well the power take-off turns that into electricity. Tested values spread widely, from a few per cent to over 50%, and real plants run at low load factors.
Chart: Efficiency ranges
Record In service CommercialEfficiency by measure
| Measure | Range | Type | What is measured |
|---|---|---|---|
| Oscillating water columns | 2 to 71%1 | Record | Hydrodynamic or pneumatic efficiency in tests and models (71% is a lab peak at resonance); the full-scale Pico sea trial gave 20% pneumatic |
| Heaving point absorbers (buoys) | 3 to 51%1 | Record | Hydrodynamic efficiency, tests and models; best results from the Wavebob design |
| Pitching attenuator (Pelamis) | 14 to 21%1 | In service | Hydrodynamic efficiency at different sites |
| Overtopping (Wave Dragon) | 18 to 27%1 | In service | Hydrodynamic efficiency, sea trial and simulation |
| Surge flaps (Oyster-type), tank tests | 35 to 65%1 | Record | Hydrodynamic efficiency in a wave tank |
| Power take-off | 55 to 95%1 | Commercial | Mechanical or pneumatic power to electricity: air turbine 55%, hydraulic 65%, direct-drive linear generator 95% |
| Mutriku OWC breakwater, 2024 | 8%23 | In service | Capacity factor: 210 MWh from 296 kW (calculated) |
Where the energy is lost
| Step | Loss |
|---|---|
| Waves passing, reflecting or out of tune with the device | most of the incident power for many designs1 |
| Air turbine in an oscillating water column | about 40-50% of pneumatic power (calculated from 50-60% turbine efficiency)2 |
| Downtime for repairs | availability 70-80% in 2010-2012 estimates2 |
There is no single theoretical limit like the Betz limit for wind, because absorption depends on device shape and tuning to the wave period. A floating body can absorb power from a crest wider than itself, which is why a few lab results look high. Comparing devices is hard: reviewers note that efficiencies are measured at different stages (pneumatic, mechanical, electrical) and under different wave climates.
Sources
- Review on Power Performance and Efficiency of Wave Energy Converters (Aderinto and Li, Energies 12, 4329), Tables 3-8 MDPI (copy hosted by PNNL Tethys), 2019
- Wave Energy: Technology Brief IRENA, 2014
- Ocean Energy: Key Trends and Statistics 2024 Ocean Energy Europe (copy hosted by PNNL Tethys), 2025