Material Insights · Understanding the Material World

Iron smelting (bloomery): Overview

What it does

The job the technology does for people, in a short paragraph

A bloomery turns iron ore into wrought iron, a tough metal for tools, nails and weapons. It works below the melting point of iron and gives a spongy lump, the bloom, that smiths hammer into shape [2]. Iron smelting began in Anatolia in the early 2nd millennium BCE [1] and the bloomery stayed the main way to make iron until blast furnaces took over [5].

as of 2026-11-10

How it works

The working principle in plain words, step by step

A bloomery is a clay shaft filled with charcoal and broken ore. Bellows blow air in at the bottom. Charcoal burns to carbon monoxide, which takes oxygen from the iron oxides and leaves metallic iron [2]. Iron oxide turns to metal at roughly 1,250 °C, well below iron's melting point of 1,538 °C [3], so the iron forms as solid specks that weld together into a bloom. The rock in the ore, mixed with some iron, melts into a slag, often fayalite, an iron silicate, that runs off or stays trapped in the bloom [2]. The smith then reheats and hammers the bloom to squeeze out slag and close up the metal.

as of 2026-11-10

Key figures

The handful of numbers that size it up, each with its unit, year and source

FigureValueUnitYearSource
Melting point of pure iron1538°C– [3]
Temperature at which iron oxide becomes metallic iron1250°C– [3]
Typical bloom, pre-Roman Iron Age2kg– [2]
Average European bloom, late bloomery era300kg– [2]
World direct reduced iron output, the bloomery's modern heir144.1million t2024[8]

as of 2026-11-10

Where it is used

The main places and products the technology is found in

  • Wrought iron for tools, nails and farm implements in the ancient and medieval world
  • Raw iron for blacksmiths before blast furnaces
  • Japanese tatara steel (tamahagane) for traditional swords
  • Experimental archaeology and craft smelting

as of 2026-11-10

Scale today

How much of it there is now: units in use, made each year and who uses it

Installed
No commercial bloomeries; the Nittoho Tatara in Japan, revived in 1977, is the only traditional tatara still working there [4]
Unit
furnaces
Year
2026
Note
Industrial iron is made in blast furnaces and by direct reduction, which made 144.1 million t in 2024 [8].

as of 2026-11-10

Sources

  1. The Innovation and Adoption of Iron in the Ancient Near East (Erb-Satullo, Journal of Archaeological Research) Springer, 2019
  2. Wikipedia: Bloomery
  3. Wikipedia: Smelting
  4. Present-day ironmaking at Nittoho Tatara (Japan Tourism Agency multilingual commentary database) Japan Tourism Agency, Ministry of Land, Infrastructure, Transport and Tourism
  5. Introduction to the archaeometallurgy of iron (Donald B. Wagner) donwagner.dk, 2024
  6. World Steel in Figures 2025 World Steel Association, 2025