Vehicle wiring harness
The bundle of wires and connectors that carries power and signals around a vehicle.
Parts and semi-finished goods · No. 77
- Electrical and chemical age
A car's wiring weighs about 25 kg, roughly half of it copper, and most of the work of making it is still done by hand.
Chart: Illustration: Vehicle wiring harness
Where it comes from
Chart: Map of where it comes from
Yazaki's founder began selling wire harnesses in Japan in 1929, and in the US Packard Electric was an established maker of car harnesses by 1932. A harness of 1949 held about 35 m of wire; by 1990 it was about 2,000 m, and some cars now carry up to 5,000 m.
Three things to know
- A compact battery electric car's harness holds about 17.1 kg of copper, against about 11.6 kg in a similar combustion car, in a 2022 study for the copper industry.
- Aluminium wire needs a cross-section about 56% larger than copper to conduct as well, so switching would cut harness weight by only about 10 to 20%.
- About 60% of the copper in a vehicle sits in the wire harness and the engine, and pulling the harness out before shredding is the main way to keep copper out of steel scrap.
The journey
- 1 CopperDrawn into fine strands; aluminium is used in a small share of wiring
- 2 Insulated wireStrands are coated with plastic, usually PVC
- 3 Cut, strip and terminateWires are cut to length, stripped and fitted with metal terminals
- 4 Harness assemblyWorkers route wires on an assembly board and tape them into bundles, mostly by hand, then every harness is tested
- 5 CarFitted by the carmaker to carry power and signals to lights, controls and, in electric cars, the battery and motor
- 6 End of lifeUsually shredded with the car, so copper ends up in steel scrap unless the harness is pulled out first