Bernoulli's principle: Technologies
Technologies
The technologies that rely on it, and how each one uses it
Relied on by 21- Clp Water clock The speed of water leaving a hole depends on the height of water above it, which sets how fast the level falls and how the hour marks must be spaced.
- Sa Sail Air speeds up over the curved lee side of a sail, and the lower pressure there adds to the driving force.
- Rud Sternpost rudder Water flowing faster round one side of the angled rudder has lower pressure, so the rudder is pushed sideways and turns the stern.
- Apl Powered fixed-wing aeroplane The faster air over a wing's upper surface has lower pressure, which is how the lift a wing makes shows up as a pressure difference; pitot tubes use the same rule to measure airspeed.
- CCGT Gas turbines and combined cycle Shaped blades speed up and turn the gas flow, trading pressure for speed and pushing the rotor round.
- Trb Engine exhaust recovery In a turbocharger the hot exhaust speeds up through the turbine, trading its pressure for speed that spins the wheel.
- TX Pressure and flow recovery Where a gas or liquid must be let down in pressure, an expander turns that pressure into flow speed and then into shaft work instead of wasting it in a valve.
- HyD Hydropower dams Water falling from the reservoir turns its height into pressure and speed in the penstock, which the turbine takes as power.
- HyR Run-of-river and small hydro Like large plants, it turns the height of falling water into speed and pressure at the turbine.
- PHS Pumped hydro storage Water pumped uphill stores energy as height, and running it back down turns that height into pressure and speed at the turbine.
Show 11 more
- TdP Tidal and ocean-current power The difference in water level across a barrage, or the speed of a tidal stream, is turned into flow through a turbine.
- WEC Wave energy converters Many wave devices drive water or air through a narrow duct, where the flow speeds up and its energy is taken by a turbine.
- WOn Onshore wind The classic limit on how much of the wind's energy a rotor can take is worked out with Bernoulli's equation on either side of the rotor.
- GP Gas pipelines and city gas Engineers use the energy form of Bernoulli's equation, with friction losses added, to work out how pressure falls along the line and where compressors are needed.
- OP Oil and product pipelines The same energy balance, with friction losses added, sets how far apart pumping stations must be.
- Pas Passive solar and natural cooling Wind blowing over and around a building lowers the pressure on the downwind side and over openings, which draws fresh air through for natural ventilation.
- WSm Small, airborne and traditional wind Bernoulli's study of how pressure, density and velocity relate in moving fluids explains the pressure drop over a blade.
- ST Steam turbines and thermal power plants Fixed blades work as nozzles that trade steam pressure for speed before the jet strikes the moving blades.
- Aeroplane The pressure difference between the upper and lower surface of a wing is part of the explanation of lift.
- Centrifugal water pump The casing turns the speed given to the water by the impeller into pressure.
- Steam turbine Fixed blades trade steam pressure for speed before the moving blades.
as of 2026-11-10