Material Insights · Understanding the Material World

Drip irrigation: Overview

What it does

The job the technology does for people, in a short paragraph

Drip irrigation waters crops by letting water seep slowly from small emitters placed next to each plant, so only part of the soil is wetted [2]. Farmers who switch to it can cut their water use by 30 to 60% [5]. It was developed in Israel from 1959 [1] and first used commercially on US vegetables in 1963 [3]. It is used mainly for vegetables, soft fruit, orchards and vines [2].

as of 2026-11-11

How it works

The working principle in plain words, step by step

A pump takes water from a well, canal or tank and pushes it into a network of pipes at a set pressure [2]. Filters, often beds of graded sand, take out fine particles, because the emitter passages are narrow and block easily [2]. Fertiliser can be fed into the water in measured doses, so each plant gets nutrients with its water [2]. Main pipes of PVC or polyethylene carry the water to thin lateral lines laid along the crop rows, on the surface or buried [2]. Along each lateral, emitters, also called drippers, release a small, steady flow onto the soil [2]. The water spreads sideways and down into a wet bulb around the roots, while the soil between rows stays dry [2]. Because little water falls on leaves or bare ground, less is lost to evaporation and runoff.

as of 2026-11-11

Key figures

The handful of numbers that size it up, each with its unit, year and source

FigureValueUnitYearSource
Water flow from one emitter, top of the 2 to 20 range20litres per hour– [2]
Cut in water use for farmers switching to drip, low end of the 30 to 60 range30%2001[5, 8]
Cost to install a drip system, low end of the 1,200 to 2,500 range1200USD per hectare2001[5, 8]
US land under micro-irrigation, of about 56 million irrigated acres6million acres2018[4]
Share of Israel's irrigated land under micro-irrigation70%1991[4]

as of 2026-11-11. The emitter flow is a design range from the FAO manual, not a dated figure [2]. The saving and cost figures carry no year in the FAO text; 2001 is the publication year of the report [5, 8], not the year of the data. US figures count all micro-irrigation, which includes micro-sprinklers [4].

Where it is used

The main places and products the technology is found in

  • Vegetable and soft fruit fields, often under plastic mulch
  • Orchards and vineyards
  • Greenhouses and nurseries
  • Dry regions such as Israel, Spain and California, where water is scarce
  • Gardens and landscaping

as of 2026-11-11

Scale today

How much of it there is now: units in use, made each year and who uses it

Installed
Nearly 6 million acres of micro-irrigation in the United States in 2018; 20 countries each had at least 1 million acres in 2017
Unit
acres irrigated
Year
2018
Note
Counts micro-irrigation as a whole, mostly drip; no recent world total was found in the sources opened [4].

as of 2026-11-11

Sources

  1. Simcha Blass Wikipedia
  2. Irrigation Water Management: Irrigation Methods, Chapter 6: Drip irrigation (Training Manual No. 5) FAO
  3. Introduction to Drip Irrigation of Vegetable Crops and the Short Course (W.J. Lamont Jr., HortTechnology 2(1)) American Society for Horticultural Science
  4. 14.2: History and Impact (Irrigation Systems Management, AET 021) LibreTexts Workforce, 2025
  5. Crops and Drops: Improving irrigated production FAO
  6. Crops and drops: making the best use of water for agriculture (AGRIS record) FAO, AGRIS, 2001