Material Insights · Understanding the Material World

Energy in buildings: Science

Principles

The science it rests on, with why each principle matters to it

Limited by
  • Heat conduction (Fourier's law) Heat leaks through walls, roofs and windows by conduction, so insulation sets how much heating or cooling a building needs.
Relies on
  • First law of thermodynamics The heat a heating system supplies must balance the heat lost through the envelope and with leaking air.
  • Second law of thermodynamics Heat flows on its own only from warm to cold, so cooling a building, or heating it with outdoor heat, needs a heat pump and work.
  • Infrared radiation Warm surfaces lose heat as infrared radiation, which low-emissivity window coatings reflect back into the room.

as of 2026-11-10

Discoveries

The discoveries that made it possible: when, by whom and what was found

YearWhoWhat
1831Michael FaradayDiscovered electromagnetic induction, the basis of the generators that supply buildings with electricity [9]
1840James JouleFormulated the law of the heat produced by an electric current, the principle of electric heaters [10]
1852William Thomson (Lord Kelvin)Proposed heating and cooling buildings with compressed and expanded air, the first published description of a heat pump [11]

as of 2026-11-10

Physical limits

The limits nature sets, today's best and how far there is still to go

LimitValueUnitBest todayGap
Heat lost through the envelope, set by insulation, airtightness and the indoor to outdoor temperature difference– kWh/(m2 y)The first passive house, in Darmstadt, lived in since 1991, used about 10 kWh of heat per square metre a year (reported 2006) [5]There is no fixed floor: with enough insulation and heat recovery, sunshine, people and appliances cover most of the need
Share of a hob's energy that reaches the pan100%Induction about 85%, resistance 75 to 80%, gas about 32% [6]Heat escapes to the air around the pan and into the hob itself

as of 2026-11-10

The science explained

The science behind it explained for a curious reader

Think of a heated house as a bucket with holes, kept full by a tap. The water level is the indoor temperature, the holes are the walls, windows and draughts, and the tap is the boiler or heat pump. Heat always runs from warm to cold, so on a cold day it pours out faster and the tap must run harder. There are two ways to save energy: a more efficient tap, or smaller holes. Insulation and airtight construction shrink the holes, and heat recovery catches the warmth in stale air before it leaves. Taken far enough, the holes get so small that body heat, cooking and sunshine almost keep the bucket full: the first passive house in Darmstadt, lived in since 1991, was using only about 10 kWh of heat per square metre a year in 2006 [5].

as of 2026-11-10

Sources

  1. 10 Years Conference on Passive Houses Passive House Institute, 2006
  2. 2021 ENERGY STAR Emerging Technology Award: Residential Induction Cooking Tops US EPA ENERGY STAR, 2021
  3. Michael Faraday (biography) The Institution of Engineering and Technology (IET Archives)
  4. James Joule (Magnet Academy: Pioneers) National High Magnetic Field Laboratory
  5. Scotland's role in the development of heat pumps: 1850 to 2050 (IESIS Presidential Address) Institution of Engineers and Shipbuilders in Scotland (Andy Pearson), 2020, Andy Pearson, IESIS Presidential Address, section 3