Material Insights · Understanding the Material World

Electrical loss reduction: Overview

What it does

The job the technology does for people, in a short paragraph

Electrical loss reduction wastes less of the electricity that is made. In the United States about 5% of the electricity transmitted and distributed was lost in 2018 through 2022 [1]. Three measures cut those losses: power-factor correction, which trims the useless reactive current in wires; more efficient transformers; and thicker or better conductors. The US Department of Energy expects its 2024 transformer standard to save 4.6 quadrillion Btu over 30 years [3].

as of 2026-11-12

How it works

The working principle in plain words, step by step

Every wire, transformer and motor loses some power as heat, and the heat grows with the square of the current. Power factor is the ratio of working power to apparent power [2]. Motors and other inductive loads draw extra reactive current that does no work but still heats the wires. Capacitors or synchronous condensers placed near the load supply that reactive current locally, so the grid delivers less total current [2]. With less current, losses fall: losses caused by poor power factor are due to reactive current flowing in the system [2]. Transformers lose power in their steel core and their windings; better core steel cuts the core loss, and lower-resistance copper windings cut the winding loss [10]. Thicker or better conductors lower the resistance, and so the heat. Many utilities charge for poor power factor, through kVA billing or reactive power charges, which pays for correction [2].

as of 2026-11-12

Key figures

The handful of numbers that size it up, each with its unit, year and source

FigureValueUnitYearSource
Share of electricity transmitted and distributed in the United States that is lost (average)5%2022[1]
Reduction in losses from correcting power factor from 0.80 to 0.95 (calculated)29%– [2]
Distribution transformers mounted on utility poles in the United States, more than60million2024[4]
Energy saved by the 2024 US distribution transformer standard over 30 years4.6quadrillion Btu2024[3]
Electricity cost saved each year by the same standard824million USD2024[3]

as of 2026-11-12. The 5% is the average for 2018 through 2022, shown as 2022 [1]. The 29% is calculated from the loss-reduction formula in the Eaton guide: 100 minus 100 times (0.80 divided by 0.95) squared, about 29.1 [2]. The pole count and the yearly saving carry 2024, the year of the articles [3][4]. The DOE standard takes effect in 2029 [4].

Where it is used

The main places and products the technology is found in

  • Factories and large buildings that fit capacitor banks or synchronous condensers to avoid power-factor charges [2][9]
  • Utility grids, where synchronous condensers supply reactive power, as in the first high-voltage unit shipped to Ontario Hydro in 1919 [5]
  • Distribution transformers on poles and in substations, where efficiency standards now apply [3][4]

as of 2026-11-12

Scale today

How much of it there is now: units in use, made each year and who uses it

Installed
More than 60 million distribution transformers on US utility poles [4]
Users
All electricity networks and large industrial users
Unit
transformers (United States)
Note
No world count of capacitors, condensers or low-loss wiring was found. The pole transformer count is for the United States only.

as of 2026-11-12

Sources

  1. How much electricity is lost in electricity transmission and distribution in the United States? (FAQ) US EIA, 2023
  2. Power factor correction: A guide for the plant engineer Eaton, 2024
  3. DOE finalizes energy efficiency standards for distribution transformers (press release, 4 April 2024) US Department of Energy, 2024
  4. DOE final distribution transformer rule adds 2 years for compliance Utility Dive, 2024
  5. GE's Industry-Leading Portfolio of Synchronous Condensers Celebrates 100th Anniversary General Electric, 2019
  6. Solving power-factor problems (Knisley) EC&M (Electrical Construction and Maintenance), 1998
  7. DOE Mandates Higher Efficiency for Distribution Transformers, Sees $Billions in Benefits Copper Development Association