Electrical loss reduction: Science
Principles
The science it rests on, with why each principle matters to it
Limited by- Ohm's law Current through a resistance always makes heat, so some loss is unavoidable; Ohm published the law in 1827 [7].
- Electromagnetic induction A transformer steps voltage up and down by induction, which Faraday found in 1831 [8]; higher voltage means lower current and lower line loss.
as of 2026-11-12
Discoveries
The discoveries that made it possible: when, by whom and what was found
| Year | Who | What |
|---|---|---|
| 1827 | Georg Ohm | Published Die galvanische Kette, mathematisch bearbeitet, giving the law linking voltage and current [7] |
| 1831 | Michael Faraday | Induced an electric current in a second coil, the basis of the transformer [8] |
| 1892 | Charles Steinmetz | Ran the experiment from which the history of power theory, including reactive power, is dated [6] |
as of 2026-11-12
Physical limits
The limits nature sets, today's best and how far there is still to go
| Limit | Value | Unit | Best today | Gap |
|---|---|---|---|---|
| Power factor cannot exceed unity: at 1.0 all current does useful work | 1 | ratio | Eaton advises correcting to approximately 95% for maximum benefit [2] | Eaton finds that correcting to about 0.95 gives the most benefit [2], so the practical aim stops short of 1.0. |
| Resistive loss in any conductor is never zero | – | % | US transmission and distribution losses averaged about 5% in 2018 through 2022 [1] | Losses can be cut by thicker conductors, higher voltage and better transformers, but not removed. |
as of 2026-11-12
The science explained
The science behind it explained for a curious reader
Think of a pipe carrying beer to a bar. The bar wants beer, but some of the flow just sloshes back and forth in the pipe and never reaches a glass. That sloshing is reactive current. It does no useful work, yet it fills the pipe, and it heats the wires just as a real current does. Power factor is the share of the flow that does work [2]. Fitting a capacitor next to the motor is like a small tank beside the bar that takes the sloshing, so the pipe from the cellar carries only the beer. Because heating in a wire grows with the square of the current, which follows from Ohm's law of 1827 [7], even a modest cut in current gives a big cut in loss: the Eaton formula puts the gain from raising power factor from 0.8 to 0.95 at roughly 29% of the losses (calculated) [2]. Transformers work by induction, found in 1831 [8], and lose some power in their cores.
as of 2026-11-12
Sources
- How much electricity is lost in electricity transmission and distribution in the United States? (FAQ) US EIA, 2023
- Power factor correction: A guide for the plant engineer Eaton, 2024
- From Steinmetz to currents' physical components (CPC): History of power theory development (Czarnecki) ICATE 2016 proceedings, via LSU Scholarly Repository, 2016
- Ohm's Law Engineering and Technology History Wiki (IEEE)
- Michael Faraday's ring-coil apparatus Royal Institution