LNG cold and cryogenic recovery: Science
Principles
The science it rests on, with why each principle matters to it
Relies on- Joule-Thomson effect A fluid expanded from high to low pressure can cool [6]; liquefying air relies on this cooling, and LNG cold recovery can also use the expansion energy released as the liquid swells about 600 times into gas [1].
- Latent heat Warming LNG into gas takes in the heat of a phase change without a rise in temperature [5], and that is the cold the terminal can use.
as of 2026-11-12
Discoveries
The discoveries that made it possible: when, by whom and what was found
| Year | Who | What |
|---|---|---|
| 1762 | Joseph Black | Gave the first account of latent heat, absorbed or released in a change of phase [5] |
| 1824 | Sadi Carnot | Showed that an ideal engine's efficiency depends only on its temperature difference, the reason a large gap between cold LNG and warmer water is useful [7] |
| 1852 | James Joule and William Thomson | First observed the cooling of a fluid expanded through a restriction, the Joule-Thomson effect [6] |
as of 2026-11-12
Physical limits
The limits nature sets, today's best and how far there is still to go
| Limit | Value | Unit | Best today | Gap |
|---|---|---|---|---|
| Energy given up as cold when LNG is regasified, around 830 kJ per kg (about 230 kWh per tonne, calculated) | 830 | kJ/kg | Cryogenic power generation with a propane Rankine cycle gives 23 kWh of electricity per tonne; chilling gas turbine intake air can use up to 180 kWh of cold per tonne [2] | No like-for-like gap can be given: the 830 kJ/kg is energy, not the smaller part of it that could become work, and the sources opened give no exergy figure [4][2]. |
Estimate · as of 2026-11-12. An estimate: the kWh per tonne value is converted from the review's kJ/kg (830 kJ/kg divided by 3.6 is about 230 kWh/t).
The science explained
The science behind it explained for a curious reader
A tonne of LNG is a tank of liquid that wants to warm up. At a terminal it is warmed to 15 to 20°C and swells to about 600 times its volume as gas [1]. Boiling takes in latent heat without a rise in temperature [5], so the liquid stays cold until it has all turned to gas. The simple way to waste that is to run seawater over it. The clever way is to run a heat engine between the cold LNG and warmer water: Carnot showed in 1824 that the bigger the temperature gap, the more work an ideal engine can give [7]. Air separation uses the cold another way, since air must be chilled to become liquid, and the cold LNG does much of the chilling.
as of 2026-11-12
Sources
- Cold energy extracts value from the LNG supply chain (trade report, 2016) Riviera Maritime Media, 2016
- Utilization of Cold Energy in Intermediate Fluid-type Vaporizer (IFV) for LNG Receiving Terminals Kobelco Technology Review No. 39 (Suzuki, Egashira, Sumida, Kobe Steel), 2021
- LNG cold energy utilization: Prospects and challenges (He, Chong, Zheng, Ju, Linga), Energy 170: 557-568 Elsevier (via RePEc IDEAS), 2019
- April 23, 1762: Joseph Black and Latent Heat American Physical Society, APS News, 2012
- Joule-Thomson Effect Cold Facts (Cryogenic Society of America)
- June 12, 1824: Sadi Carnot Publishes Treatise on Heat Engines APS News, American Physical Society, 2009