Organic Rankine, Kalina and sCO2 cycles: Science
Principles
The science it rests on, with why each principle matters to it
Relies on- Carnot's limit on heat engines Carnot showed in 1824 that an ideal engine's efficiency depends on its temperature difference [11]; with low-temperature heat that gap is small, and real Rankine cycles reach 30 to 50% of the Carnot figure [4].
- Latent heat The working fluid absorbs heat as it boils and gives it up as it condenses at constant temperature [12]; the organic fluid is chosen to boil at a low temperature [4].
as of 2026-11-12
Discoveries
The discoveries that made it possible: when, by whom and what was found
| Year | Who | What |
|---|---|---|
| 1762 | Joseph Black | Gave the first account of latent heat, the heat absorbed in a change of phase [12] |
| 1824 | Sadi Carnot | Showed that an ideal engine's efficiency depends only on its temperature difference [11] |
| 1859 | William J. M. Rankine | Published a complete theory of the steam engine in his manual [3] |
as of 2026-11-12
Physical limits
The limits nature sets, today's best and how far there is still to go
| Limit | Value | Unit | Best today | Gap |
|---|---|---|---|---|
| Carnot efficiency for heat at 200°F (about 366 K), the low end the DOE gives for ORC operation, rejected at an assumed 288 K (about 15°C) | 21 | % | Rankine cycles in waste heat to power typically reach 30 to 50% of the Carnot efficiency [4], about 6 to 11% at this temperature (calculated) | Calculated estimate: 1 minus 288/366 is about 21%; at 30 to 50% of that, at least half of the Carnot output is not captured. |
| Ideal efficiency of a supercritical CO2 recompression cycle with a 550°C heat source | 48 | % | The US pilot targets a 500°C turbine inlet; no measured efficiency is given in the source opened [8] | The 48% is a modelled ideal value [7]; the sources opened give no measured plant efficiency. |
Estimate · as of 2026-11-12. The first row is a calculation from the DOE's lowest operating temperature [4] and an assumed 288 K surroundings; no source publishes it. The second is a modelled ideal value [7].
The science explained
The science behind it explained for a curious reader
A steam turbine is like a water wheel that needs a steep drop. Water boiled by hot gas gives high-pressure steam, a steep drop. With only lukewarm heat the steam pressure is too low to be worth the trouble. The fix is to use a fluid that boils at a much lower temperature than water [4], so the same loop of boil, spin, condense and pump works on weaker heat. The Kalina cycle uses a mixture of two fluids, ammonia and water [4]. Carbon dioxide above its critical point of 31.1°C and 73.8 bar [7] is not a liquid or a gas but something dense in between, so a supercritical CO2 loop can use a compact turbine. All depend on the temperature difference, as Carnot showed in 1824 [11], so real cycles reach 30 to 50% of the Carnot limit [4].
as of 2026-11-12
Sources
- History KCORC (Kalina Cycle and Organic Rankine Cycle knowledge centre)
- Waste Heat to Power, CHP Technology Fact Sheet Series (DOE/EE-2347) US Department of Energy, 2021
- Supercritical CO2 Power Technology: Strengths but Challenges Energies 17(5), 1129 (Molière, Privat, Jaubert, Geiger), 2024
- STEP Demo pilot plant achieves full operational conditions for Phase 1 of testing Southwest Research Institute, 2024
- June 12, 1824: Sadi Carnot Publishes Treatise on Heat Engines APS News, American Physical Society, 2009
- April 23, 1762: Joseph Black and Latent Heat American Physical Society, APS News, 2012