Sensible heat storage: Overview
What it does
The job the technology does for people, in a short paragraph
Sensible heat stores keep heat for later by warming a material such as water, rock or molten salt. The household hot water tank, patented in automatic form in 1889 [1], is the commonest example. Larger stores hold solar or waste heat for district heating across the seasons, and molten salt tanks let solar power plants run after dark. IRENA estimated that over 234 GWh of thermal storage was installed worldwide at the end of 2019 [2].
as of 2026-11-12
How it works
The working principle in plain words, step by step
Heat goes into a material and raises its temperature; the hotter it gets, the more energy it holds. Water is the usual choice because each kilogram needs 4,184 joules to warm by one degree, far more than most materials [5]. A heater, solar collector or exhaust stream warms the store, often through a heat exchanger, a set of pipes that passes heat without mixing the fluids. Insulation slows the leak of heat to the surroundings. To take heat out, a cooler fluid is passed through, warmed and sent to taps, radiators or a steam turbine. Molten salt stores work the same way at several hundred degrees, which lets them make steam for power at night [2][3].
as of 2026-11-12
Key figures
The handful of numbers that size it up, each with its unit, year and source
| Figure | Value | Unit | Year | Source |
|---|---|---|---|---|
| Thermal energy storage installed worldwide | 234 | GWh | 2019 | [2] |
| Molten salt storage installed worldwide | 21 | GWh | 2020 | [2] |
| Cost of sensible heat storage, including water tanks | 35 | USD/kWh | 2020 | [2] |
| Water volume of the Vojens pit store, Denmark | 200,000 | m3 | 2015 | [4] |
| Heat needed to warm 1 kg of water by 1 C | 4184 | J | – | [5] |
as of 2026-11-12. The 234 GWh counts all thermal storage, latent and chemical as well as sensible, at the end of 2019 [2]; the molten salt and cost figures are given as current in a 2020 report, and the year shown is the report's.
Where it is used
The main places and products the technology is found in
- Household and commercial hot water tanks [1][2]
- Seasonal pit stores for solar district heating, such as Vojens in Denmark [4]
- Aquifer and borehole stores that hold heat underground in large volumes [2]
- Molten salt tanks at solar power towers, demonstrated at Solar Two in California [3][2]
as of 2026-11-12
Scale today
How much of it there is now: units in use, made each year and who uses it
- Installed
- Over 234 GWh of thermal storage of all kinds worldwide, including over 21 GWh of molten salt [2]
- Unit
- GWh
- Year
- 2019
- Note
- IRENA's count of all thermal storage at the end of 2019; it could triple to over 800 GWh by 2030 [2]. No later world count was found in the sources opened.
as of 2026-11-12
Sources
- Heater, Water (object record, gift of Brian Tischler) Senator John Heinz History Center, Pittsburgh (collections online)
- Innovation Outlook: Thermal Energy Storage IRENA, 2020
- Solar two: A molten salt power tower demonstration (SAND--95-1828C) Sandia National Laboratories, via OSTI
- World largest thermal pit storage in Vojens State of Green
- Specific Heat Capacity and Water US Geological Survey, Water Science School