Steam turbines and thermal power plants: Science
Principles
The science it rests on, with why each principle matters to it
Limited by- Carnot's limit on heat engines Carnot showed that the share of heat a steam plant can turn into work is set by the temperatures it works between [8], so plants push steam ever hotter.
- Second law of thermodynamics Some heat must always be rejected to a cold sink; in coal and nuclear steam plants about two thirds of the energy is lost this way [7].
- Latent heat Boiling water takes in a large amount of heat, and the condenser must give that heat up again, which is why so much is lost to cooling water.
- Bernoulli's principle Fixed blades work as nozzles that trade steam pressure for speed before the jet strikes the moving blades.
as of 2026-11-11
Discoveries
The discoveries that made it possible: when, by whom and what was found
| Year | Who | What |
|---|---|---|
| 1824 | Sadi Carnot | Showed that a heat engine's work is capped by the temperatures of its hot and cold bodies [8] |
| 1848 | William Thomson (Lord Kelvin) | Recognised the importance of Carnot's work, which he and others built into the science of thermodynamics [8] |
| 1850 | Rudolf Clausius | Showed that Carnot's theorem was correct, the root of the second law of thermodynamics [8] |
as of 2026-11-11
Physical limits
The limits nature sets, today's best and how far there is still to go
| Limit | Value | Unit | Best today | Gap |
|---|---|---|---|---|
| Carnot limit between the steam temperature and the cooling water | – | % | 49.37% net (lower heating value) at Pingshan Phase II, a 1,350 MW coal unit [4] | Heat is added over a range of temperatures, flue gas leaves warm and the turbine has friction losses |
| Steam temperature that boiler tubes and turbine parts can survive (the advanced ultra-supercritical target) | 760 | °C | A US consortium had developed and tested nickel alloys for steam up to 760 °C by the end of 2015; the record Pingshan unit uses mature 600 °C-class materials [6][4] | Hotter steam needs costly nickel alloys in place of steel |
as of 2026-11-11
The science explained
The science behind it explained for a curious reader
Think of a steam plant as a waterfall for heat. Heat falls from the hot boiler to the cold condenser, and the turbine sits in the fall and catches part of it as work, the way a water wheel catches part of a falling stream. Carnot showed in 1824 that the share you can catch depends only on how high the fall is, from the hot temperature to the cold one [8]. The cold end is fixed by the river or sea that cools the condenser, so engineers raise the hot end: from saturated steam to supercritical steam, where water turns to vapour without boiling, and towards 760 °C with nickel alloys [6]. Even so, in coal and nuclear steam plants about two thirds of the energy ends up as warm cooling water [7].
as of 2026-11-11
Sources
- China's Pingshan Phase II Sets New Bar as World's Most Efficient Coal Power Plant POWER Magazine, 2023
- Materials Matter: The Advanced Ultrasupercritical Boiler Consortium Power Engineering, 2016
- Cooling Power Plants World Nuclear Association, 2026, page updated 8 September 2026
- Carnot, Nicolas Léonard Sadi Encyclopedia.com (Encyclopedia of World Biography; Complete Dictionary of Scientific Biography)