Macadam and tarmac roads: Overview
What it does
The job the technology does for people, in a short paragraph
A macadam road gives wheeled traffic a smooth, hard, dry surface without the deep stone foundations of earlier roads. John Loudon McAdam put the method into practice on the Bristol roads from 1815 and published it in 1816 [1, 2]. It spread through the turnpike trusts and reached the United States by 1823 [3, 6]. Bound with tar from 1902, it became tarmac [4].
as of 2026-11-10
How it works
The working principle in plain words, step by step
McAdam saw that the native soil carries the weight of traffic as long as it is kept dry [5]. So the road is built on drained ground and covered with a layer of broken stone that sheds rain. The stones are broken small and sharp-edged: no piece heavier than six ounces, about 170 g, in a layer about ten inches, or 25 cm, deep [5]. Traffic and rolling press the angular pieces together so that they lock into a firm crust, filled by fine dust. The surface is raised slightly in the middle, three inches on a road 30 feet wide, so water runs off to the sides [5]. Tar macadam adds a binder: the stone is mixed with tar, which glues the pieces together and seals the surface against water and dust [4].
as of 2026-11-10
Key figures
The handful of numbers that size it up, each with its unit, year and source
| Figure | Value | Unit | Year | Source |
|---|---|---|---|---|
| Depth of broken stone in a McAdam road | 25 | cm | – | [5] |
| Heaviest single stone allowed | 170 | g | – | [5] |
| Rise from side to centre on a 9.1 m (30 foot) wide road | 7.6 | cm | – | [5] |
| Length of the Bristol road network under McAdam | 128 | km | – | [1] |
| Road trusts McAdam advised by 1818 | 34 | trusts | 1818 | [7] |
as of 2026-11-10. McAdam gives ten inches, six ounces and three inches in 30 feet [5]; the metric values are converted and rounded (about). The Boonsborough Turnpike in the United States used the same six-ounce rule, or stones that pass a two-inch ring [6].
Where it is used
The main places and products the technology is found in
- Turnpike and country roads in Britain and abroad [3, 6]
- Base layers of modern roads, made of graded crushed stone
- Tar macadam surfaces on streets, paths and car parks
- Farm and estate roads with unbound stone surfaces
as of 2026-11-10
Scale today
How much of it there is now: units in use, made each year and who uses it
- Installed
- No count found; the layered crushed-stone base McAdam pioneered lies under most modern roads
- Note
- Road statistics count roads by surface type, not by method, so macadam is not counted on its own.
as of 2026-11-10
Sources
- John Loudon McAdam (1756-1836) European Route of Industrial Heritage (ERIH)
- John Loudon McAdam Encyclopaedia Britannica
- Wikipedia: Macadam
- Tarmac Grace's Guide to British Industrial History
- Remarks on the Present System of Road Making (seventh edition) John Loudon McAdam; Longman, Hurst, Rees, Orme, and Brown, London (Project Gutenberg edition), 1823
- Rakeman Paintings: First American Macadam Road, 1823 U.S. Federal Highway Administration
- John Loudon McAdam American Society of Civil Engineers (ASCE)