Gas turbine: Interventions
Interventions
Changes that would cut emissions or material use, by lever and life stage, with effect per unit, readiness, adoption, evidence and who acts
| Lever | Life stage | Change | Effect per unit | Readiness | Adoption | Who acts | Source |
|---|---|---|---|---|---|---|---|
| Efficiency | Use | Add a steam cycle on the exhaust (combined cycle) instead of running the turbine alone | GE quotes over 64% in combined cycle against 44.0% for the 9HA.02 alone, so about 31% less fuel per kWh (calculated as 1 minus 44.0/64) | Deployed | Not found; the US combined-cycle fleet ran at 57% capacity factor in 2022 [18] | Utilities and plant developers | [4][18] |
| Substitute | Use | Burn hydrogen or a hydrogen blend instead of natural gas | In the 16 MW study, use-stage emissions were about 604 kg CO2e per MWh on natural gas and 197.7 on hydrogen from electrolysis with renewable power, a cut of about 67% (calculated); the hydrogen figure is the footprint of making the hydrogen | Piloted: Siemens Energy says proven technology exists for blends of up to 80% hydrogen, depending on the product, and targets 100% by 2030 | Not found | Turbine makers, fuel suppliers, utilities | [2][25] |
| Change route | Use | Capture the carbon dioxide from the exhaust | Not quantified in the sources opened; the low CO2 concentration in the exhaust makes capture harder | Mature amine solutions are described as ready for deployment; the US rule that based standards for new base-load turbines on capture is repealed from 16 November 2026 | Not found | Plant owners, regulators | [26][23][30] |
| Circularity | End of life | Recycle superalloy scrap and other metals instead of landfilling them | The study says about 80% of a unit's materials are recyclable, but counted none of it; rhenium is already recovered from superalloy scrap [2][8] | Deployed for rhenium; no rate for the other metals | Not found | Turbine makers, scrap processors | [2][8] |
| Design | Components design | Raise the turbine inlet temperature with better cooling and coatings | Not quantified; a 2021 review describes a next-generation turbine designed for 1650 degrees C against 1350 for the F-class M701F4 | Research and development for 1650 degrees C | Not found | Turbine makers | [7] |
as of 2026-11-13
Sources
- Life cycle assessment of a gas turbine installation in the Russian Federation (Global Energy 30(2), 74-87; in Russian) Peter the Great St Petersburg Polytechnic University, 2024
- 9HA Gas Turbine: 9HA.01 and 9HA.02 (product page) GE Vernova
- Test-Rig Simulation on Hybrid Thermal Barrier Coating Assisted with Cooling Air System for Advanced Gas Turbine under Prolonged Exposures: A Review MDPI, Coatings 11(5), 560, 2021
- Mineral Commodity Summaries 2026: Rhenium US Geological Survey, 2026
- Natural gas combined-cycle power plants increased utilization with improved technology US Energy Information Administration, Today in Energy, 2023
- Fact sheet: final repeal of the 2024 carbon pollution standards and supplemental proposal US Environmental Protection Agency, 2026
- Energy Transition is on the Horizon (gas turbine decarbonisation flyer) Siemens Energy, 2022
- Decarbonisation pathways for gas turbines Modern Power Systems
- B-338762: EPA, Partial Repeal of the Carbon Pollution Standards for Fossil Fuel-Fired Electric Generating Units (major rule report) US Government Accountability Office, 2026