Additive manufacturing (3D printing): Materials
Materials it needs
The commodities and chemicals it needs per unit, its share of each one's demand and how critical each is
Uses- EPX Epoxy resins criticality low Light-curing resins for stereolithography are acrylate and epoxy based.
- PA Nylon (PA6, PA66) criticality low Nylon powder is the usual material for laser sintering of plastic parts.
- PLA Lactic acid and PLA criticality low PLA filament is the common material of desktop printers.
- Ti Titanium criticality high Titanium alloy powder is printed into implants and aircraft parts; titanium metal is on the EU critical and strategic lists [9].
- Ni Nickel criticality medium Nickel superalloy powders are printed into engine parts; battery-grade nickel is on the EU lists [9].
- Al Aluminium criticality medium Aluminium alloy powders are printed for light parts; aluminium is on the EU critical and strategic lists [9].
- St Steel criticality low Stainless and tool steel powders are printed into tooling and parts.
as of 2026-11-11. No source opened gives amounts per part; materials were about 20% of the industry's revenue in 2024 [5]. Criticality is the writer's judgement from the EU lists.
Critical materials
The materials whose supply could hold it back
- Titanium metal: on both the EU critical and strategic raw material lists [9], and printed into implants and aircraft parts.
- Aluminium: bauxite, alumina and aluminium are on both EU lists [9].
- No plastic used in printing is on a critical list; their supply follows the wider plastics market.
as of 2026-11-11
Sources
- RMIS - Critical and Strategic Materials European Commission, Joint Research Centre, Raw Materials Information System