OTEC and salinity power: Overview
What it does
The job the technology does for people, in a short paragraph
These plants make electricity from differences in the sea itself. OTEC uses the gap of 20 °C or more between warm tropical surface water and cold water pumped up from 800 to 1,000 m [2][3]. Salinity power uses the energy released when river water meets sea water [4]. Both were proposed long ago, OTEC in 1881 [1], but only pilot plants exist, such as a 50 kW OTEC plant completed in Okinawa in 2013 [2].
as of 2026-11-11
How it works
The working principle in plain words, step by step
A closed-cycle OTEC plant is a heat engine. Warm surface water boils a liquid with a low boiling point, mostly ammonia, and the vapour spins a turbine [2]. Cold water pumped from deep below then condenses the vapour back to liquid, and the cycle repeats. An open-cycle plant boils the sea water itself at low pressure [2]. Because the temperature gap is small, at most about 7% of the heat can become work, and pumping the water takes 20 to 30% of the output [2]. Salinity power uses membranes: in pressure retarded osmosis, fresh water seeps through a membrane into salt water, building pressure that drives a turbine; in reverse electrodialysis, salt ions moving through membranes create a voltage directly [4].
as of 2026-11-11
Key figures
The handful of numbers that size it up, each with its unit, year and source
| Figure | Value | Unit | Year | Source |
|---|---|---|---|---|
| Output of the Kumejima OTEC pilot plant, Okinawa, when completed | 50 | kW | 2013 | [2] |
| Output of Georges Claude's first OTEC system, Cuba | 22 | kW | 1930 | [1] |
| Smallest sea temperature difference OTEC generally needs | 20 | °C | 2014 | [2] |
| Highest Carnot efficiency at OTEC temperatures | 7 | % | 2014 | [2] |
| Estimated global technical potential of salinity gradient power | 647 | GW | 2014 | [4] |
as of 2026-11-11. IRENA lists the Kumejima plant at 50 kW [2], and its control system supplier gave an initial 50 kW, expandable to 100 kW [8]; Japan's government describes the project as at the 100 kW level [3]. The temperature gap, Carnot ceiling and salinity potential carry 2014, the publication year of the IRENA briefs, not a data year. The salinity potential is equal to 5,177 TWh a year, 23% of electricity consumption in 2011 [4].
Where it is used
The main places and products the technology is found in
- Pilot OTEC plants on tropical islands, such as Kumejima in Okinawa [3]
- Deep sea water for fish farming, farming and district cooling next to OTEC plants [3]
- Proposed floating OTEC plants for remote islands in tropical seas [2]
- Pilot salinity plants at river mouths and estuaries [4]
as of 2026-11-11
Scale today
How much of it there is now: units in use, made each year and who uses it
- Installed
- Pilot plants only, such as Kumejima, completed at 50 kW in 2013 [2] and described by Japan's government as at the 100 kW level [3]
- Users
- Remote islands in tropical seas are the main target market [2]
- Unit
- kW
- Year
- 2013
- Note
- An open-cycle experimental plant in Hawaii, with a turbine designed for 210 kW, ran from 1993 to 1998 [7]; Statkraft's 10 kW osmotic pilot has been stopped [4].
as of 2026-11-11
Sources
- Achievements in OTEC Technology (archived copy of the NREL page, 7 October 2012) National Renewable Energy Laboratory (archived by the UNT Libraries web archive)
- Ocean Thermal Energy Conversion: Technology Brief IRENA, 2014
- Ocean Thermal Energy Conversion - Making the Dream a Reality Highlighting Japan, Government of Japan (gov-online.go.jp), 2023
- Salinity Gradient Energy: Technology Brief IRENA, 2014
- Ocean Thermal Energy Conversion Primer L. A. Vega, Marine Technology Society Journal, vol. 36, no. 4 (copy hosted by PNNL Tethys), pp. 25 to 35