Thermochemical storage: Science
Principles
The science it rests on, with why each principle matters to it
Relies on- Chemical equilibrium (Le Chatelier's principle) A reversible reaction shifts one way when heated and the other way when cooled or given water vapour, which is what charges and discharges the store; Le Chatelier set out the principle in 1884 [5].
- Heat conduction (Fourier's law) Salt hydrates conduct heat poorly and water vapour moves slowly through their grains, which slows charging and discharging; composites are made to overcome this [4].
as of 2026-11-12
Discoveries
The discoveries that made it possible: when, by whom and what was found
| Year | Who | What |
|---|---|---|
| 1884 | Henry Le Chatelier | Stated the general principle for how a system in chemical equilibrium responds to a change in temperature or pressure [5] |
| 1976 | Researchers publishing on magnesium chloride | Magnesium chloride first appears in the literature for thermochemical water splitting, later a storage salt [2] |
| 1981 | Researchers publishing on magnesium sulphate | Magnesium sulphate is first published, a salt with high theoretical storage density [2] |
as of 2026-11-12
Physical limits
The limits nature sets, today's best and how far there is still to go
| Limit | Value | Unit | Best today | Gap |
|---|---|---|---|---|
| Theoretical energy density of the reaction: magnesium sulphate stores up to this much | 2.8 | GJ/m3 | No working store found near this; the 1 GJ/m3 system target for a home store is far from reached, and laboratory materials barely survive 20 cycles [1][2] | The gap is one of durability and engineering, not thermodynamics: salts swell, cake together and melt if over-hydrated, and heat and vapour must move through the bed [2][4]. |
as of 2026-11-12
The science explained
The science behind it explained for a curious reader
Think of a spring wound tight and held by a catch. Winding it took energy, and holding it costs nothing, however long you wait. A thermochemical store is a chemical spring. Heat pulls water out of a salt hydrate or a zeolite, and the dry solid and the water are kept apart, like the wound spring and its catch [2]. The energy stays locked in that separation, so the store loses almost nothing over months [1]. Releasing the catch means letting water vapour back in: the solid takes it up and gives out the stored heat. Le Chatelier's principle of 1884 says that a system in equilibrium pushes back against a change in temperature [5], which is why heating drives the water out and adding water brings the heat back. The hard part is wear: salts swell, cake and can melt as they cycle [4].
as of 2026-11-12
Sources
- A review of salt hydrates for seasonal heat storage in domestic applications (Donkers et al., Applied Energy 199, 45-68) Eindhoven University of Technology repository, 2017
- Water sorption-based thermochemical storage materials: A review from material candidates to manufacturing routes (Palacios, Navarro, Barreneche and Ding) Frontiers in Thermal Engineering, vol. 2, 2022
- Salt Hydrate Adsorption Material-Based Thermochemical Energy Storage for Space Heating Application: A Review (Yang et al.) Energies, vol. 16, article 2875, 2023
- Henry-Louis Le Chatelier Encyclopaedia Britannica