Material Insights · Understanding the Material World

Industrial robot: Science

Principles

The science it rests on, with why each principle matters to it

Relies on
  • Feedback control theory Every joint is a servomechanism that measures its angle and corrects its motor to follow the planned path.
  • Trigonometry The controller turns a tool position in space into joint angles, and back, using the geometry of the links.
Limited by
  • Newton's laws of motion Moving heavy links and loads fast takes force and torque, so the arm's mass and its motors limit speed and payload.

as of 2026-11-11

Discoveries

The discoveries that made it possible: when, by whom and what was found

YearWhoWhat
1868James Clerk MaxwellFirst mathematical analysis of a feedback governor [7]
1927Harold BlackNegative feedback found to cut distortion in amplifiers, a key idea for stable control [7]
1934Harold HazenSummary of servomechanism theory, the basis of position control [7]

as of 2026-11-11

The science explained

The science behind it explained for a curious reader

Hold your arm out and touch your nose with your eyes shut. Your brain knows the length of each bone and sets the angles of shoulder, elbow and wrist to bring a fingertip to one point. A robot does the same with arithmetic. Given where the tool must go, the controller solves the geometry of its links for the joint angles. Then each joint motor turns, a sensor reports the angle, and any error is corrected at once. This is feedback, the idea Maxwell first analysed for governors in 1868 [7]. The heavier the arm and its load, the more force it needs to start and stop, so speed and reach trade off against payload.

as of 2026-11-11

Sources

  1. A History of Automatic Control C. C. Bissell (chapter in a Springer handbook, ISBN 978-3-540-78830-0; Lund University course copy)