Screw-cutting lathe: Overview
What it does
The job the technology does for people, in a short paragraph
A screw-cutting lathe cuts accurate, identical screw threads on a turning bar. Before it, threads were cut crudely by hand [1]. Jesse Ramsden built such lathes in the 1770s for the screws of his dividing engines [3], and Henry Maudslay's hand-driven lathe of about 1800 began the making of accurate threads for engineering [1]. The same principle cuts threads on lathes today.
as of 2026-11-11
How it works
The working principle in plain words, step by step
The work turns in the lathe's spindle. A long lead screw runs beside it and moves the slide rest that carries the cutting tool [1]. The lead screw is linked to the spindle by change wheels, a set of gears [1]. For every turn of the work, the tool moves along by a fixed distance, so it cuts a helix with an exact, even pitch. Changing the gear ratio changes the pitch. Ramsden even used the gears to cancel errors: his lead screw was 1% out, and change wheels of 198 and 200 teeth corrected it [3]. The hard part is the first accurate lead screw, since every later screw copies it [2].
as of 2026-11-11
Key figures
The handful of numbers that size it up, each with its unit, year and source
| Figure | Value | Unit | Year | Source |
|---|---|---|---|---|
| Pitch error of Ramsden's lead screw, corrected by change wheels | 1 | % | – | [3] |
| Error of Ramsden's dividing engine, under | 0.5 | arc second | 1775 | [4] |
| Thread flank angle proposed by Whitworth | 55 | degrees | 1841 | [5] |
| Thread angle proposed by Sellers | 60 | degrees | 1864 | [5] |
as of 2026-11-11. The dividing-engine error is the Dictionary of Scientific Biography's figure [4]; Grace's Guide gives a claimed error of under one second for Ramsden's engine of 1774 [6]. The thread angles are the years they were proposed [5].
Where it is used
The main places and products the technology is found in
- Lead screws that move the tools of other machine tools
- Fasteners: bolts, nuts and screws
- Measuring instruments such as dividing engines and micrometers
- Engine, pump and pipe threads
as of 2026-11-11
Scale today
How much of it there is now: units in use, made each year and who uses it
- Installed
- No count found
- Unit
- lathes able to cut threads
- Note
- No source opened counts screw-cutting lathes; thread cutting is now a standard function of most lathes.
as of 2026-11-11
Sources
- Henry Maudslay's original screw-cutting lathe, c.1800 Science Museum Group Collection
- Machine-Screw thread making tool, by Henry Maudslay Science Museum Group Collection
- Jesse Ramsden Grace's Guide to British Industrial History
- Ramsden, Jesse (Dictionary of Scientific Biography entry) Roderick S. Webster, Dictionary of Scientific Biography (MacTutor, University of St Andrews copy)
- Historical Background to Screw Threads Bolt Science