Material Insights · Understanding the Material World

Prestressed concrete: Overview

What it does

The job the technology does for people, in a short paragraph

Prestressed concrete lets concrete beams, slabs and bridge decks span further and stay thinner without cracking. Steel tendons pulled tight squeeze the concrete before any load arrives, so under service loads it is never stretched. Patented by Freyssinet in 1928 and first used in 1934 [1], it spread after the Second World War; today more than 70% of US bridges are prestressed concrete [3].

as of 2026-11-11

How it works

The working principle in plain words, step by step

Concrete is strong when squeezed but weak when pulled, so a loaded beam cracks on its stretched underside. Prestressing removes that stretch in advance. High-strength steel wires or strands are pulled tight with hydraulic jacks and then locked to the concrete. In pre-tensioning the strands are stretched across a casting bed, concrete is poured around them, and once it has hardened the strands are released and grip the concrete. In post-tensioning the concrete is cast around empty ducts; tendons are threaded through, stretched against the hardened concrete and held by anchors at the ends. Either way the steel tries to shorten and so keeps the concrete compressed. When traffic or floor loads bend the beam, they only reduce this squeeze instead of pulling the concrete apart. The steel must be stretched far, because concrete slowly shrinks and creeps and would otherwise release the prestress [1].

as of 2026-11-11

Key figures

The handful of numbers that size it up, each with its unit, year and source

FigureValueUnitYearSource
Share of US bridges built of prestressed concrete70% (more than)2008[3]
Main span of Walnut Lane Memorial Bridge, the first major North American example49m1950[3]
Strength of prestressing steel used by Freyssinet in the 1930s1310MPa (1310 to 1380)– [1]
Sinking rate of the Le Havre Maritime Station before its prestressed rescue25mm per month1933[1]

as of 2026-11-11. The US share is from a STRUCTURE magazine article of October 2008; 2008 is its publication year, not a data year, and the share covers bridges of all ages. The Le Havre sinking is the rate given for the station completed in 1933, before the 1934 rescue. The steel strength is the low end of the 1310 to 1380 MPa range the PCI paper gives for the 1930s.

Where it is used

The main places and products the technology is found in

  • Bridge girders and box-girder decks
  • Floor slabs and beams in car parks, offices and flats
  • Precast hollow-core planks and railway sleepers
  • Liquid storage tanks, silos and nuclear containment shells
  • Electricity poles and piles

as of 2026-11-11

Scale today

How much of it there is now: units in use, made each year and who uses it

Installed
More than 70% of bridges in the United States are prestressed concrete [3]
Unit
share of bridges
Note
No opened source gives world output of prestressed concrete or prestressing steel.

as of 2026-11-11

Sources

  1. Eugène Freyssinet - The Origins of Prestressed Concrete (P. Xercavins, D. Demarthe and K. Shushkewich) Precast/Prestressed Concrete Institute (PCI), 2008
  2. Walnut Lane Memorial Bridge, by George D. Nasser (STRUCTURE magazine, October 2008, pp. 27 to 31) STRUCTURE magazine (NCSEA, CASE and SEI), 2008