Puddling (wrought iron): Overview
What it does
The job the technology does for people, in a short paragraph
Puddling turned brittle pig iron into tough, workable wrought iron, with under 0.5% carbon [5], in coal-fired furnaces. Henry Cort patented it in 1784 [1], and it became Britain's main way of making wrought iron: output rose from 32,000 t in 1788 to 150,000 t in 1815 [1]. Wrought iron output peaked around 1890, as steel took over [1].
as of 2026-11-11
How it works
The working principle in plain words, step by step
A puddling furnace is a reverberatory furnace: coal or coke burns on a grate at one end, and its flame sweeps over a shallow hearth, so the fuel never touches the iron [1][2]. A charge of about 230 to 270 kg of pig iron melts in about 30 minutes [1]. The puddler then stirs it with an iron bar, pushing it against a slag rich in iron oxide. The oxide gives its oxygen to the carbon in the iron, which leaves as carbon monoxide; the bubbling is called the boil [1]. As the carbon goes, the iron stiffens into a pasty mass of grains wrapped in slag [1]. The puddler gathers it into balls, which are squeezed and hammered to drive out slag and then rolled into bars [1].
as of 2026-11-11
Key figures
The handful of numbers that size it up, each with its unit, year and source
| Figure | Value | Unit | Year | Source |
|---|---|---|---|---|
| British wrought iron output | 150,000 | t | 1815 | [1] |
| British wrought iron output | 32,000 | t | 1788 | [1] |
| Pig iron charged per furnace heat, up to | 270 | kg | 2009 | [1] |
| Share of the iron charged that could be lost in slag in dry puddling, up to | 50 | % | 2009 | [1] |
| Carbon in wrought iron, typically less than | 0.5 | % | 2010 | [5] |
as of 2026-11-11. The 2009 and 2010 years are publication years of sources describing nineteenth-century practice [1][5].
Where it is used
The main places and products the technology is found in
- Wrought iron bars for smiths, engineers and ironworks [1]
- Iron ship plates and fittings; the first fully wrought iron passenger ship was built in 1843 [4]
- Wrought iron made by the Aston process in the United States from 1920 [1]
as of 2026-11-11
Scale today
How much of it there is now: units in use, made each year and who uses it
- Installed
- None in commercial use; wrought iron output in Britain and the United States peaked around 1890 [1]
- Unit
- t
- Year
- 1890
- Note
- By about 1900 wrought iron was only about 15% of wrought iron and steel output together [1]; a 1930 Aston plant could make over 1,000 t a day without hand puddling [1].
as of 2026-11-11
Sources
- Puddling: a metallurgical perspective (Merton C. Flemings and David V. Ragone), Historical Metallurgy 43(2), pp. 103 to 108 Historical Metallurgy Society, 2009
- Introduction to the archaeometallurgy of iron (Donald B. Wagner) donwagner.dk, 2024
- Wood to welding: The evolution of shipbuilding materials Lloyd's Register Foundation Heritage and Education Centre
- Archaeology Datasheet 302: Steelmaking Historical Metallurgy Society, 2010