Material Insights · Understanding the Material World

Tunnelling shield: Overview

What it does

The job the technology does for people, in a short paragraph

A tunnelling shield lets people dig through soft, wet ground that would collapse onto an open face. It holds up the ground around the face while workers dig and a lining is built behind it. Brunel patented the first in 1818 [1] and used it on the Thames Tunnel from 1825 [3]. Its descendants, shield tunnel boring machines, now dig metro, rail and sewer tunnels, such as the 42 km of the Elizabeth line [4].

as of 2026-11-11

How it works

The working principle in plain words, step by step

The shield is a strong frame the size of the tunnel, set hard against the face. A stave on top of each section holds up the earth above [1], and boards at the front hold up the face itself. Workers inside the frame take out a small strip of ground, then push the frame forward into the gap, using large screws in Brunel's design [1]. Behind it, bricklayers or fitters build the permanent lining before the ground can move: brick arches on the Thames Tunnel [1], rings of segments today [4]. The cycle repeats, so the tunnel is never left unsupported for long. Greathead's round shield of 1870 [3] and modern machines work the same way, but a rotating cutter digs the face and hydraulic jacks push off the finished lining.

as of 2026-11-11

Key figures

The handful of numbers that size it up, each with its unit, year and source

FigureValueUnitYearSource
Sections in Brunel's shield, each holding three workmen12sections– [1]
Advance of the Thames Tunnel on a good day0.9m (about 3 ft)– [1]
Width of the first Greathead shield2.2m (7.25 ft)1870[3]
Length of new Crossrail tunnels dug by eight boring machines42km2022[4]
Concrete lining segments used for the Crossrail tunnels200,000segments (over)2022[4]

as of 2026-11-11. Brunel's shield was used from 1825 to 1843 [3]. The Crossrail rows are given at the opening of the central section in 2022 [4]; the 0.9 m and 2.2 m are calculated from feet.

Where it is used

The main places and products the technology is found in

  • Metro and underground railway tunnels in soft ground
  • Tunnels under rivers and estuaries
  • Main-line rail tunnels under cities, such as the Elizabeth line
  • Sewer, water and cable tunnels

as of 2026-11-11

Scale today

How much of it there is now: units in use, made each year and who uses it

Installed
Shield-driven tunnels run under many large cities; the Elizabeth line alone, opened in 2022, added 42 km under London [4]
Unit
km of tunnel
Year
2022
Note
No opened source counts shield-driven tunnels worldwide.

as of 2026-11-11

Sources

  1. Thames Tunnel American Society of Civil Engineers, Historic Landmarks
  2. James Henry Greathead Linda Hall Library
  3. Crossrail - the Elizabeth line Institution of Civil Engineers