Carbon fibre and composite parts: Interventions
Interventions
Changes that would cut emissions or material use, by lever and life stage, with effect per unit, readiness, adoption, evidence and who acts
| Lever | Life stage | Change | Effect per unit | Readiness | Adoption | Who acts | Source |
|---|---|---|---|---|---|---|---|
| Change route | Making | Make the acrylonitrile precursor from bio-based feedstock | Could cut the fibre's global warming potential by 5 to 9 kg CO2e per kg of fibre (not per kg of part) [6] | The source says it 'could immediately reduce' emissions; no deployment stated | Not stated | Fibre makers, chemical suppliers | [6] |
| Electrify | Making | Run fibre making on net zero electricity | Net zero electricity by 2050 alone can give an almost 50% cut in the fibre's global warming potential [6] | Depends on grid supply | Not stated | Fibre makers, power suppliers | [6] |
| Change route | Making | Use biomethane for the heat | Cuts the current global warming potential of carbon fibre products by around 20% [6] | Not stated | Not stated | Fibre makers, gas suppliers | [6] |
| Design | Components design | Use carbon fibre only where stiffness is needed, as in wind blade spar caps, and make it with less carbon | In a typical offshore blade the spar cap carbon is 12% of mass but around 50% of the lifetime carbon footprint; fibre made from 2040 onwards could cut blade global warming potential by more than 50% [6] | Deployed in blades; lower-carbon fibre is a scenario | Wind blades took 44.5% of fibre demand in 2025 [1] | Blade designers, fibre makers | [6, 1] |
| Circularity | End of life | Recover fibre from composite scrap and end-of-life parts | Fluidised-bed recovery needs 7.7 MJ per kg of recycled fibre against a median 562 MJ per kg for virgin fibre; fibre from pyrolysis can keep 90% or more of its original performance [3, 4] | Deployed at small scale: one UK plant (RCF Ltd) had about 1,200 tonnes a year of output capacity in 2010 [11] | In the UK up to 98% of composite waste is landfilled or incinerated (no year given) [5] | Recyclers, airframers, wind operators | [3, 4, 5, 11] |
as of 2026-11-13
Sources
- ATA 2025 global carbon fiber composites market report documents record demand CompositesWorld, 2026
- A critical review and meta-analysis of energy demand, carbon footprint, and other environmental impacts from carbon fiber manufacturing Resources, Conservation & Recycling, vol. 219, 108302 (Chen, Liddell, Ogale, Miao, Ijeoma, Carbajales-Dale), 2025
- Comparing Life Cycle Energy and Global Warming Potential of Carbon Fibre Composite Recycling Technologies and Waste Management Options University of Nottingham repository, accepted manuscript; published in ACS Sustainable Chemistry & Engineering, vol. 6, no. 8, pp. 9854 to 9865 (Meng, Olivetti, Zhao, Chang, Pickering, McKechnie), 2018
- Energy and environmental assessment and reuse of fluidised bed recycled carbon fibres University of Nottingham repository, accepted manuscript; published in Composites Part A, vol. 100, pp. 206 to 214 (Meng, McKechnie, Turner, Pickering), 2017
- Net zero carbon fibres: Drop-in decarbonisation solutions National Composites Centre (NCC), SusWIND
- Carbon fiber reclamation: Going commercial CompositesWorld (Karen Wood), 2010