Fracture mechanics: The idea
In plain words
The idea explained without jargon
Solids are full of tiny scratches and cracks. Stress gathers at the sharp tip of a crack, so the material there is pulled far harder than elsewhere [1, 3]. Griffith asked when such a crack will grow. A growing crack lets the stretched material around it relax, which frees stored energy, but it also has to make new surface, which costs energy [1]. Once the energy freed is larger than the energy cost, the crack runs on by itself. Longer cracks free more energy, so a solid with a long crack breaks at a lower stress [1, 7]. That is why real materials are much weaker than their atomic bonds suggest, and why a material's toughness, its resistance to a growing crack, matters as much as its strength [1, 5].
as of 2026-11-10
Key equation
The equation that sums it up, and what each symbol means
- Equation
- sigma_f = sqrt(2 E gamma / (pi a))
- Symbols
- {"sigma_f":"the stress at which the cracked plate breaks, in pascals","E":"the material's stiffness (Young's modulus), in pascals","gamma":"the energy needed to make one square metre of new surface, in joules per square metre","a":"half the length of a crack running through the plate, in metres","pi":"the number pi"}
- Note
- This is Griffith's result for a brittle plate in plane stress as course notes write it: the breaking stress falls as one over the square root of the crack length [7]. For metals, Irwin wrote the same balance in terms of a stress intensity factor, and a crack grows when that factor reaches a value measured for the material, its fracture toughness [5, 7].
as of 2026-11-10
An analogy
A picture from everyday life that makes the idea easier to hold
Think of tearing a sheet of paper. Without a nick it is hard to start; with a small tear at the edge, a gentle pull runs it right across, and the longer the tear, the easier the next bit. The picture stops being true for tough metals: they bend and stretch at the tip of a crack, which soaks up much more energy than the new surface alone.
as of 2026-11-10
Sources
- The Phenomena of Rupture and Flow in Solids A. A. Griffith, Philosophical Transactions of the Royal Society of London, Series A, vol. 221 (scan on the Internet Archive), 1920, pp. 163 to 198
- Mechanics of solids: Stress concentrations and fracture Encyclopaedia Britannica
- George R. Irwin James W. Dally, in Memorial Tributes: Volume 10, National Academy of Engineering, 2002, pp. 146 to 153
- Introduction to Fracture Mechanics David Roylance, Department of Materials Science and Engineering, MIT (MIT OpenCourseWare, 3.11 Mechanics of Materials), 2001