Material Insights · Understanding the Material World

Numerical control machining: Science

Principles

The science it rests on, with why each principle matters to it

Relies on
  • Feedback control theory Each axis is a servomechanism: the controller compares the commanded position with the measured one and drives the motor to close the gap.
  • Euclidean geometry Tool paths are built from points, lines, arcs and surfaces in a coordinate frame, which is what the program describes.

as of 2026-11-11

Discoveries

The discoveries that made it possible: when, by whom and what was found

YearWhoWhat
1868James Clerk MaxwellFirst mathematical analysis of a feedback governor [6]
1932Harry NyquistStability criterion for feedback systems [6]
1934Harold HazenSummary of servomechanism theory, the basis of position control [6]

as of 2026-11-11

The science explained

The science behind it explained for a curious reader

Think of steering a car along a painted line. You look where the car is, compare it with the line and turn the wheel to correct, again and again. A numerically controlled axis does the same, only faster and with numbers. The program says where the tool should be at each instant. A sensor reports where it is. The difference drives the motor, and as the gap closes the push eases. Maxwell first analysed such loops in 1868 [6], and later engineers learned how to keep them from overshooting and oscillating [6]. Run three or five such loops together and the tool can trace any curve in space.

as of 2026-11-11

Sources

  1. A History of Automatic Control C. C. Bissell (chapter in a Springer handbook, ISBN 978-3-540-78830-0; Lund University course copy)