Carnot batteries: Overview
What it does
The job the technology does for people, in a short paragraph
A Carnot battery stores spare electricity as heat and later turns the heat back into electricity, offering long-duration storage built from cheap materials such as rock, sand or salt. The idea goes back to a patent of 1924 [1][6]. The best-known plant, in Hamburg, was commissioned in 2019 [1]. Designs are still mostly at pilot scale, with round-trip efficiencies typically between 30% and 70% [1].
as of 2026-11-12
How it works
The working principle in plain words, step by step
Charging turns electricity into heat. The simplest way is an electric heater; the cleverer way is a heat pump, which moves heat from a cold store into a hot store and so puts in more heat than the electricity it uses. The heat waits in an insulated store: a packed bed of rock, tanks of molten salt or bins of hot sand [1][2]. Discharging runs a heat engine, such as a steam or gas turbine, between the hot store and the cold side, and the turbine drives a generator. A heater-based system can only return what a steam cycle can recover, about 25% at the Hamburg plant [1]. Heat-pump designs, called pumped thermal energy storage, can do much better: modelled designs reach 57% to 66% [2].
as of 2026-11-12
Key figures
The handful of numbers that size it up, each with its unit, year and source
| Figure | Value | Unit | Year | Source |
|---|---|---|---|---|
| Heat storage capacity of the Siemens Gamesa ETES plant, Hamburg | 130 | MWh thermal | 2019 | [1] |
| Round-trip efficiency of the ETES plant | 25 | % | 2022 | [1] |
| Thermodynamic round-trip efficiency of Isentropic's 150 kW pumped heat demonstrator, tested at reduced power | 77 | % | 2022 | [1] |
| Modelled round-trip efficiency of particle (silica) pumped thermal storage | 66 | % | 2025 | [2] |
| Modelled levelised cost of storage, particle design, 10-hour discharge | 0.115 | USD/kWh | 2025 | [2] |
as of 2026-11-12. The ETES capacity is for the plant commissioned in 2019 [1]. The two measured efficiencies carry 2022, the publication year of the review that reports them, not the year they were measured [1]; the demonstrator figure excludes mechanical and electrical losses [1]. The particle figures are modelled, not measured, and 2025 is the study's publication year [2].
Where it is used
The main places and products the technology is found in
- Pilot grid storage with rock beds and steam turbines, as at Hamburg [1]
- Pumped heat demonstrators with gas cycles and two thermal stores [1]
- Proposed long-duration storage of 10 to 1,000 hours [2]
as of 2026-11-12
Scale today
How much of it there is now: units in use, made each year and who uses it
- Installed
- A few pilot and demonstration plants, the best known being the 130 MWh thermal ETES plant in Hamburg [1]
- Unit
- MWh thermal
- Year
- 2022
- Note
- No world total of installed Carnot batteries was found; the 2022 review lists pilot projects rather than a fleet [1]. 2022 is the review's publication year.
as of 2026-11-12
Sources
- Review of Carnot Battery Technology Commercial Development (Novotny et al., Energies 15(2), 647) MDPI, 2022
- Advancing Pumped Thermal Energy Storage Performance and Cost Using Silica Storage Media (Applied Energy 387, 125567) National Laboratory of the Rockies (formerly NREL), 2025
- Pumped Thermal Energy Storage Technology (PTES): Review Thermo 3(3), 396 to 411 (Rabi, Radulovic and Buick), MDPI, 2023