Mechanical power transmission: Efficiency and losses
Near-perfect gears, but air systems that waste most of their power
Rigid mechanical links are very efficient over short distances: 95 to 99% for gears and belts. Fluid systems are far worse end to end: about 22% on average for US fluid power and only 12 to 17% for industrial compressed air, with leaks alone wasting 20 to 30% of compressor output in poorly maintained plants.
Chart: Efficiency ranges
Lost in transit Whole chainLosses by measure
| Measure | Range | Type | What is measured |
|---|---|---|---|
| Gear mesh, best-designed high-power gears | 98 to 99%6 | Lost in transit | Share of input power delivered per gear stage |
| V-belt, new, against synchronous belt | 95 to 98%1 | Lost in transit | Peak V-belt efficiency of 95% or more at installation; synchronous belt about 98% across loads |
| V-belt slip with poor tensioning | 5%1 | Lost in transit | Efficiency that can be lost over time if belts are not retensioned |
| Hydraulic systems, mobile against industrial | 21 to 50%2 | Whole chain | Average whole-system efficiency, input energy to useful work, US estimate |
| Industrial pneumatic (compressed-air) systems | 12 to 17%2 | Whole chain | Whole-system efficiency including the compressor; downstream of the compressor 23 to 30% |
| Compressed-air leaks | 20 to 30%3 | Lost in transit | Share of compressor output lost to leaks in a poorly maintained plant; under 10% is the good-practice target |
Holding periods and inventory
| Measure | Value |
|---|---|
| Compressed-air receivers and pipes | Leaks continue whenever the system is pressurised; leakage is measured by timing how fast pressure falls from operating level to about half3 |
| London hydraulic network throughput (1930) | About 33 million gallons of water a week (roughly 1.7 billion a year, calculated) serving about 8,000 machines26 |
US fluid power systems use an estimated 2.0 to 2.9 quads of energy a year (2008 data), about 2 to 3% of national energy use (calculated against about 100 quads), at an average efficiency of about 22%. Raising that average to 27% through best practice could save about 0.4 quads a year, and to 37% through research about 0.8 quads. A later NREL study (2017) put mobile off-road fluid power alone at 0.36 to 1.8 quads, so the older estimate may be low.
Distance matters most for fluids: friction in pipes and leaks grow with network length, which is one reason the city-scale hydraulic and compressed-air networks of London and Paris closed once electricity could reach every building.
Sources
- Replace V-belts with notched or synchronous belt drives (Motor Systems Tip Sheet #5) US Department of Energy, Advanced Manufacturing Office, 2012
- Estimating the Impact (Energy, Emissions and Economics) of the U.S. Fluid Power Industry (ORNL/TM-2011/14), Love, Lanke and Alles Oak Ridge National Laboratory, 2012
- Compressed Air System Leaks (Improving Compressed Air System Performance, Fact Sheet #7, Rev. 1) Compressed Air Challenge, 2026
- Using the Box-Behnken response surface method to study parametric influence to improve the efficiency of helical gears (Machines 9(11), 264) MDPI, 2021
- London Hydraulic Power Co Grace's Guide to British Industrial History, 2025