Pressure and flow recovery: Science
Principles
The science it rests on, with why each principle matters to it
Relies on- First law of thermodynamics Energy is conserved, the principle that Joule's experiments of 1849 led to [7]; the pressure energy of the fluid reappears as shaft work instead of being lost in a valve.
- Bernoulli's principle Pressure in a fluid falls as its speed rises [8], which is how the gas gives up pressure while speeding through the nozzles and blades of the expander.
- Joule-Thomson effect Expanding a fluid across a valve can cool it [9]; making the gas do work in an expander cools it further [1], which is why expanders are used in refrigeration cycles.
as of 2026-11-12
Discoveries
The discoveries that made it possible: when, by whom and what was found
| Year | Who | What |
|---|---|---|
| 1738 | Daniel Bernoulli | Hydrodynamica set out the relation between a fluid's speed and its pressure [8] |
| 1849 | James Prescott Joule | Reported to the Royal Society the work that became the base of the first law of thermodynamics, the conservation of energy [7] |
| 1852 | James Joule and William Thomson | First observed the cooling of a fluid expanded from high to low pressure, the Joule-Thomson effect [9] |
as of 2026-11-12
Physical limits
The limits nature sets, today's best and how far there is still to go
| Limit | Value | Unit | Best today | Gap |
|---|---|---|---|---|
| Isentropic efficiency of an expander: the ideal expansion, with no loss, obtains 100% of the available work | 100 | % | Turboexpanders readily reach isentropic efficiencies as high as 90%, with the turbine stage between the mid-80s and low-90s [1] | Calculated: about 10 percentage points at best for gas expanders. Power recovery turbines for liquids are typically 40 to 80% [3]. |
as of 2026-11-12
The science explained
The science behind it explained for a curious reader
Open a tap at the bottom of a tall tank and the water shoots out, throwing away the height it fell. Put a water wheel in the stream and some of that fall turns the wheel. Gas under pressure is the same: let it through a valve and its pressure energy ends up as noise and a little heat, but pass it through a turbine and it turns a shaft [1]. Bernoulli found in 1738 that pressure in a moving fluid falls as its speed rises [8], and the turbine wheel catches the speed that this pressure drop creates. Because the gas does work, it also cools more than in a valve [1][9]. For desalination the trick is different: a pressure exchanger lets high-pressure brine push fresh seawater straight to high pressure, with over 95% efficiency [2].
as of 2026-11-12
Sources
- Fundamentals of turboexpander design and operation Gas Processing & LNG (T. Avetian and L. E. Rodriguez, L.A. Turbine), 2020
- Pressure exchange technology makes seawater desalination affordable WaterWorld (G. G. Pique, chief executive of Energy Recovery, Inc.), 2003
- Power recovery turbines IPIECA energy efficiency solutions (topic last reviewed 1 February 2014), 2014
- June 1849: James Prescott Joule and the Mechanical Equivalent of Heat APS News, American Physical Society, 2015
- Hydrodynamica Encyclopaedia Britannica
- Joule-Thomson Effect Cold Facts (Cryogenic Society of America)