Material Insights · Understanding the Material World

High-pressure polyethylene process

Ethylene gas squeezed at very high pressure links into polyethylene, now the most used plastic.

Making materials · Polymers · No. 24

  • Electrical and chemical age
  • Readiness 9 of 9
  • Process
Making materials · Technology

Polythene was found by accident in 1933, when a high-pressure experiment lost pressure and left a mystery waxy solid in the vessel.

Chart: Illustration: High-pressure polyethylene process

Where it comes from

Chart: Map of where it comes from

ICI chemists Reginald Gibson and Eric Fawcett were testing gases at very high pressure in 1933. Their ethylene run left a waxy solid; two years later colleagues found the trace of oxygen that made it repeatable.

Three things to know
  1. The 1933 result could not be repeated until December 1935, when chemists found that a trace of oxygen starts the reaction.
  2. Almost all of the 4,000 t of polyethylene made from 1939 to 1945 insulated radar cables.
  3. Today's tubular reactors run at 2,500 to 3,200 bar, and high-conversion designs turn 30 to 36% of the ethylene into polymer on each pass.
The journey
  1. 1 EthyleneA gas cracked from oil or gas liquids
  2. 2 CompressionSqueezed to thousands of atmospheres
  3. 3 InitiatorA trace of oxygen or a peroxide starts the chains
  4. 4 ReactorA long tube or a stirred autoclave; part of the gas turns to polymer
  5. 5 PelletsThe melt is separated, cooled and cut into pellets
  6. 6 ProductsFilm, cable coating, foam
Covered in Matter at the atomic scale: bonds, reactions and process engineeringEngineering
Go deeper pick a tab to open it in full