Material Insights · Understanding the Material World

Programmable logic controller

A rugged computer runs the logic of machines and production lines.

Making things · Automation and control · No. 497

  • Electronic age
  • Readiness 9 of 9
  • Component
Making things · Technology

A four-page request from a car gearbox plant in 1968 produced the rugged computer that still runs the logic of factory machines.

Chart: Illustration: Programmable logic controller

Where it comes from

Chart: Map of where it comes from

In 1968 General Motors' Hydra-Matic division asked for a standard machine controller to replace relay systems. Bedford Associates answered with the Modicon 084, demonstrated in November 1969, while a rival DEC machine went into service that June.

Three things to know
  1. The PLC was built to replace banks of relays, which were hard to troubleshoot and took many hours of rewiring to change.
  2. Its ladder language copied the relay diagrams electricians already knew, so they could program it without becoming programmers.
  3. The international standard for PLC programming languages, IEC 61131-3, reached its fourth edition in 2025.
The journey
  1. 1 InputsSwitches and sensors on the machine are wired to input modules
  2. 2 Input scanThe controller records every input value
  3. 3 ProgramIt runs the stored ladder or function block logic
  4. 4 Output scanIt writes the results to outputs that switch motors and valves
  5. 5 RepeatThe cycle runs again and again while the machine works
Covered in Control and systems: feedback, stability and how machines are made to behaveEngineering
Go deeper pick a tab to open it in full