Material Insights · Understanding the Material World

Seismic base isolation

Flexible bearings under a building let the ground shake beneath it.

Building and shelter · Structures · No. 440

  • Electrical and chemical age
  • Readiness 9 of 9
  • Component
Building and shelter · Technology

Put a building on rubber and lead pads and the ground can shake beneath it while the building moves far less.

Chart: Illustration: Seismic base isolation

Where it comes from

Chart: Map of where it comes from

Milne tested a building on cast-iron balls in Tokyo in 1884. Two Japanese bank buildings of 1934 were the first in use, and New Zealand's lead-rubber bearing of 1975 made the method widespread.

Three things to know
  1. John Milne put a test building in Tokyo on cast-iron balls in 1884, and its floor shook about six times less than the ground.
  2. Bill Robinson hit on the lead-rubber bearing in 1975; the William Clayton Building in Wellington, opened in 1982, stood on 80 of them.
  3. By the Kobe earthquake of January 1995 about 85 isolated buildings had been approved in Japan; by 2012 there were more than 6,500.
The journey
  1. 1 Rubber and steelThin rubber sheets are bonded between steel plates
  2. 2 Lead coreA lead plug in the centre soaks up energy in some bearings
  3. 3 Isolation layerBearings are set between the foundation and the building
  4. 4 GapA clear gap around the building, 400 mm at Te Papa, lets it move sideways
  5. 5 EarthquakeThe ground shifts under the bearings while the building moves slowly and gently
Covered in What engineers do: rules of thumb, the method and the kinds of engineering knowledgeEngineeringVibration, waves and resonance in machines and structuresEngineering
Go deeper pick a tab to open it in full