Grain-oriented electrical steel: Footprint
Raw materials in one unit
Every commodity and chemical inside one unit, traced through its components by the site, with its emission factor and emissions
| Material | Amount (kg) |
|---|---|
| Iron ore | 965 |
| Silicon | 32 |
Worked out from data
The site's estimate
Emissions of one unit worked out by the site from its materials and energy, for the world and India, with the share of mass covered by emission factors
| Stage | Place | Emissions (kg CO2e) | Mass covered by factors |
|---|---|---|---|
| Making | World | 275 | 0% |
| Use | World | – | – |
| Making | India | 402 | 0% |
| Use | India | – | – |
Worked out from data
Energy to make it
Energy used to make one unit, by carrier and stage
Energy to make- El Electricity 600 kWh · Manufacturing High-temperature anneal only, calculated: about 42,000 kWh on average to heat 70 tons of steel per cycle, so about 600 kWh per tonne, at Tata Steel's Cogent Orb Works in the UK, whose furnaces are heated by electric elements [17]. Other steps and the steelmaking are not included. The full cradle-to-gate primary energy in the thyssenkrupp EPD is 51,400 MJ non-renewable plus 3,850 MJ renewable per tonne, with no split by carrier [4].
as of 2026-11-15
Emissions by stage
Published life-cycle emissions of one unit in four stages (making, logistics, use, end of life), with their split, place and variant
| Stage | Value | Range | Unit | Place | Year | Source |
|---|---|---|---|---|---|---|
| Making | 4250 | – | kg CO2e per tonne | Germany and France | 2021 | thyssenkrupp EPD, modules A1 to A3 (cradle to gate), declared unit 1 tonne, 2021 production at Gelsenkirchen and Isbergues; residual grid mix factors 0.847 (Germany) and 0.0614 (France) kg CO2e per kWh [4] |
| Making | 3800 | 3800 to 3830 kg CO2e per tonne | kg CO2e per tonne | Japan (Nippon Steel) | 2022 | Nippon Steel Ecoleaf/SuMPO EPDs JR-AW-22020E-B and -A, entries in One Click LCA: 3.80 and 3.83 kg CO2e per kg, modules A1 to A3, publication year 2022 [5][6] |
Indicative · as of 2026-11-15. Only making (cradle to gate) is published per tonne, so shares of a life-cycle total cannot be given. Logistics and use are not in the studies, and the core's loss in use belongs to the transformer node. The EPD's end-of-life results (modules C and D) cannot be read reliably from its table, and module D is a credit outside the product boundary, so no end-of-life stage is given. The two makers differ by about 12% (calculated), by grade mix, plant, grid and year.
End of life
What happens to a unit when it is thrown away: collection, reuse, recycling and disposal shares, by place
| Route | Share | Place | Year | Source |
|---|---|---|---|---|
| Recycling (declared scenario 3) | 88 | Germany and France | 2021 | [4] |
| Reuse (declared scenario 3) | 11 | Germany and France | 2021 | [4] |
| Loss to landfill (declared scenario 3) | 1 | Germany and France | 2021 | [4] |
as of 2026-11-15. These are a scenario that the EPD declares for the steel, not a measured collection rate [4].
Recovered as
The commodities and chemicals recovered at end of life, with recovery rates
Recovered as- St Steel 88% recovered · Recycling The EPD's scenario 3 sends 88% to recycling, 11% to reuse and 1% to loss [4]; it is a declared scenario, not a measured rate.
as of 2026-11-15
End of life in India
Collection and recycling in India, including the informal sector
The sheet leaves service inside transformers, so its end of life is the transformer's. The only recovery figures found are an EPD scenario of 88% recycled and 11% reused [4]. No source opened describes how Indian transformer cores are collected or recycled, and none names a rule on extended producer responsibility for the steel. A 2016 report says scrap-grade CRGO entered India across the Nepal border and was pushed into the market with fake BIS marks [24].
as of 2026-11-15
Water and waste
Water use and waste per unit where a source gives them
| Measure | Value | Unit | Stage | Year | Source |
|---|---|---|---|---|---|
| Net fresh water use, cradle to gate | 32.6 | m3 per tonne | Manufacturing | 2021 | [4] |
| Secondary material in the product | 127 | kg per tonne | Materials | 2021 | [4] |
| Yield loss over the whole process (hot rolling alone 3.5%) | 7.3 | % of metal | Manufacturing | 2022 | [1] |
as of 2026-11-15
Sources
- Electric Grid Supply Chain Review: Large Power Transformers and High Voltage Direct Current Systems US Department of Energy, 2022
- Environmental Product Declaration EPD-TKE-20240546-CBC1-EN: powercore grain oriented electrical steel thyssenkrupp Electrical Steel, programme holder Institut Bauen und Umwelt e.V. (IBU), 2025
- EPD: Grain-oriented electrical steel sheets (JR-AW-22020E-B), Ecoleaf/SuMPO EPD, entry in the One Click LCA materials database One Click LCA, for Nippon Steel Corporation, 2022
- EPD: Grain-oriented electrical steel sheets (JR-AW-22020E-A), Ecoleaf/SuMPO EPD, entry in the One Click LCA materials database One Click LCA, for Nippon Steel Corporation, 2022
- Technologies for high-temperature batch annealing of grain-oriented electrical steel: An overview (Open Engineering 14) De Gruyter, Cardiff University repository copy, 2024
- India's steel ministry seeks greater monitoring of illegal inflow of scrap grade CRGO SteelOrbis, 2016