Material Insights · Understanding the Material World

Industrial air compressor: Footprint

Raw materials in one unit

Every commodity and chemical inside one unit, traced through its components by the site, with its emission factor and emissions

VariantMaterialAmount (kg)ThroughEmission factor (kg CO2e per kg)Emissions (kg CO2e)
VariableSteel818.9Electric motor, Heat exchanger, Variable speed drive1.921572.3
VariableCopper76.17Electric motor, Variable speed drive, Printed circuit board3.965302
VariableAluminium23.8Electric motor, Variable speed drive14.8352.2
VariableHydrochloric acid2.49Printed circuit board– –
VariableHydrogen peroxide1.46Printed circuit board– –
VariableSulphuric acid0.99Printed circuit board– –
VariablePolycarbonate0.9Variable speed drive– –

Worked out from data

The site's estimate

Emissions of one unit worked out by the site from its materials and energy, for the world and India, with the share of mass covered by emission factors

VariantStagePlaceEmissions (kg CO2e)Mass covered by factors
VariableMakingWorld243499%
VariableUseWorld2.05 million100%
VariableMakingIndia251599%
VariableUseIndia2.99 million100%

Worked out from data

Energy in use

Energy one unit uses per year of use, by carrier

Energy in use
  • El Electricity 528,500 kWh per year · lifetime 13 years Fixed-speed oil-injected screw Calculated: 75 kW of motor output divided by a motor efficiency of 0.9 is 83.3 kW of input [3]; times 8,400 hours a year (top of the DOE base-load range [10]) is 700,000 kWh at full load. The fact sheet's example machine runs 65% of the time loaded and 35% unloaded, drawing 30% of full power when unloaded [3], a load factor of 0.65 + 0.35 x 0.30 = 0.755. So 83.3 kW x 8,400 h x 0.755 = about 528,500 kWh a year; at 4,000 hours about 252,000 kWh. Over the 13-year lifetime of the US standard [11] that is about 6.9 GWh.
  • El Electricity 343,500 kWh per year · lifetime 13 years Variable-speed screw Calculated: the fixed-speed figure of about 528,500 kWh less the maker's best-case saving of up to 35% [12]; the saving depends on how much the load varies, so this is a lower bound.

as of 2026-11-16

End of life in India

Collection and recycling in India, including the informal sector

No source opened gives collection or recycling rates for industrial compressors, in India or elsewhere. The frame, casings and motor are mostly metal and are normally sold as scrap, and used lubricant oil is a hazardous waste that has to be collected. Treat this as general practice, not as a measured rate.

as of 2026-11-16

Recovered as

The commodities and chemicals recovered at end of life, with recovery rates

Recovered as
  • St Steel Recycling Frame, casings and shafts go to scrap; rate not found.
  • Cu Copper Recycling Motor windings and wiring; rate not found.
  • Al Aluminium Recycling Coolers; rate not found.

as of 2026-11-16

Sources

  1. Compressed Air Systems Fact Sheet 9: Compressed Air System Economics (May 2026, Rev. 1) Compressed Air Challenge, 2026
  2. Energy Conservation Program: Energy Conservation Standards for Compressors (notice of proposed rulemaking) US Department of Energy, 2016
  3. Energy Conservation Program: Energy Conservation Standards for Compressors (final rule, 10 January 2020) US Federal Register, 2020
  4. GA 7-90 VSD iPM oil-injected rotary screw compressors (brochure 2935 0816 48) Atlas Copco, 2022